Radio Wiring

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 25, 2005
Threads
17
Messages
96
Just Installed A Sony Stereo In My 40, Using A Painless 7 Circut Boss So As Not To Overload My Oe Fuse Block. Hooked Up The Stereo's Constant To The Circut Boss's Constant To Keep The Memory And The Other Power Wire To An Ignition Hot Wire. Worked Fine When All Was Hooked Up. Then A Few Days Later, Found My Battery Dead, Recharged...worked Fine...then A Few Days Later Dead Again. Where Can I Hook Up The Stereo's Constant Hot To Keep My Memory Without Draining My Battery. I Know ...a Newbie Question. Thanks
 
You may have a bad battery, if that's all it takes to run it down. I leave mine on (well, it's a Pioneer) for weeks at a time without trouble. You can test the battery yourself, or NAPA will generally do it for you.

You may also have another source of current draw. A little time with a multimeter may be in order.
 
The Strange Capitalization Makes It Very Hard To Read Your Post.

Measure the total cunnent drain from your battery with the truck off. Disconnect one of the battery cables and put an amp meter in between the cable and post. Then measure how much drain your radio uses with the truck off by putting an amp meter in line witht he radio power lead.

If the battery drain is much higher than the radio, then something else is causing the drain. You can find the drain by reinstalling the amp neter at the battery and pulling fuses and disconnecting things one at a time while monitoring the amp drain. Start with disconnecting the alternator as that can be a big drain if a diode is bad.
 
Back
Top Bottom