Racks, Sliders and Control Arms (1 Viewer)

[TRAIL TAILOR]

I have all the measurements in on the FJC- RLCA and RUCAs. These are available now.


Rear Lower Control Arms

Rear Upper Control Arms

Sliders and racks will be coming soon as well. Tough Dog suspensions will be in stock soon.

J

 

[BMThiker]

Just curious about the RUCA design. What is that block in the middle of the shaft?

 

[TRAIL TAILOR]

Just curious about the RUCA design. What is that block in the middle of the shaft?

Rick,

Its a wrench flat. The uppers can be adjusted while installed on the vehicle without removing a bolt and dropping an end to adjust length. Plus it acts as a backup to set the jam nuts.

Jason

 

[BMThiker]

Are they reversed threaded at the ends so it works like a turnbuckle, or same threaded? I seriously doubt it could actually happen in this application, but I wouldn't want it "backing out" to the point of altering alignment.

 

[TRAIL TAILOR]

Are they reversed threaded at the ends so it works like a turnbuckle, or same threaded? I seriously doubt it could actually happen in this application, but I wouldn't want it "backing out" to the point of altering alignment.

Yes, turnbuckle style. I or Currie have never seen one back out 3" of threads of each or either end.

J

 

[TRAIL TAILOR]

Xrox and TGT bumpers for the FJC.

J