Quick question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 20, 2016
Threads
55
Messages
449
Location
California
I'm looking forward into changing my spark plug wires and I wanted some advice since it's super hard to find a pair of new EOM wires would NGK be a good idea as a replacement?

IMG_1220.webp
 
yes, slightly larger core and also they were cheap on rockauto before
 
First off, charge your phone. It's making me uncomfortable.

Second, they're hard to come by? They were about the same price, for me, as the highest listed ones in your screenshot, so why not just get the part number (9091921557) and order some?
 
Any Toyota dealer can get you a set of new wires: #90919-21557
They come already lined up in the correct order.
Last time I called my local dealer for a mass air flow sensor they said my 94 Lc was too old and they couldn't get me one. I just assumed it would be the same case for these wires, but thanks for the info.
 
First off, charge your phone. It's making me uncomfortable.

Second, they're hard to come by? They were about the same price, for me, as the highest listed ones in your screenshot, so why not just get the part number (9091921557) and order some?
We have charger deficit in the house and thanks for your response.
 
Last time I called my local dealer for a mass air flow sensor they said my 94 Lc was too old and they couldn't get me one. I just assumed it would be the same case for these wires, but thanks for the info.

May be you got that responce from the dealer because the 94 model does not use a mass air flow sensor.
 
I have the NGK Wires and they seem to work fine.
Replaced OEM Denso Plugs.
Changed PCV-OEM, PCV Grommet (Ebay, Inshino)
Changed Cap (Ebay made in Japan) and Rotor (I think OEM)

Might want to check the resistance on your wires before you just go and change.
It's in the FSM.

DO NOT buy and aftermarket PCV. The one I had I could blow air thru. The NEW OEM one and old OEM I could not.
 
Have a long pick handy for the old spark plug wires. When I did mine each of the old wires came apart and and got stuck on the spark plug insulator (white part), the only way to get them out of that deep hole is with a pick.

upload_2016-9-20_9-5-33.webp
 
... When I did mine each of the old wires came apart and and got stuck on the spark plug insulator ...

When installing plug wires, put some silicone grease (Super Lube, brake grease, etc) on the seal locations, at the cap and plug. This will make them seal better and prevent sticking.
 
Have a long pick handy for the old spark plug wires. When I did mine each of the old wires came apart and and got stuck on the spark plug insulator (white part), the only way to get them out of that deep hole is with a pick.

View attachment 1324671

Hemostat's work well too and have a set just for this. :)
 
Back
Top Bottom