Quick front axle question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 31, 2009
Threads
20
Messages
359
Location
North Texas
Hey all. Trying to chase down a good ol death wobble issue and am tightening up my front wheel bearings as I felt a slight play. Just a quick question to see if the movement when tugging on the spindle is normal? I've learned a lot about my LC from the forum and getting out there and wrenching on it, but not sure if this is normal. Thanks for any input

 
That is totally normal. Once you add the drive flange and C-Clip at the end, it will be reduced. The shaft has to "float" to account for tolerances in the assembly. The CV will center itself along the knuckle axis when you turn.
 
Nvm. As I put it back together I remember the usefulness of the c-clip.


Hey all. Trying to chase down a good ol death wobble issue and am tightening up my front wheel bearings as I felt a slight play. Just a quick question to see if the movement when tugging on the spindle is normal? I've learned a lot about my LC from the forum and getting out there and wrenching on it, but not sure if this is normal. Thanks for any input


I
 
Yep like Golgo13 said that's not your spindle that's your birfield, it has to have some play. I think a lot of the death wobble these trucks are starting to see are worn out bushings and tie rods.
 
Back
Top Bottom