Pulls to the left when braking hard

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

NKP Garage

Forever Learning
SILVER Star
Joined
Jul 27, 2009
Threads
70
Messages
2,292
Location
Texas
Website
www.youtube.com
The truck has been doing this since I bought it recently. When braking normally it's fine, but when braking hard it pulls hard to the left. Enough that the steering wheel turns to the left and you have to struggle to keep it straight. I went over all the brake lines, pads and rotors when I was putting in the OME lift kit a few days ago and they all look fine and I can't find any leaks. On a related note, I am also losing brake fluid from somewhere. I've had to fill it up once since I bought the truck (about 400 miles put on it so far). It's not my daily driver but I'm trying to drive it as much as possible to work out all the kinks.

Any ideas?
 
Sticky piston, probably your right one, but your left one could also be the problem.

Either get reman'd OEM caliper or purchase the rebuild kit (either way from Mr. cdan). Consider new rotors as well as there's a fair chance that you've warped or worn yours. If it's pulling hard, it's most likely a front caliper, but I'd check the rears as well.

Match whatever you do, so if you rebuild the right caliper, rebuild the left as well. If you replace one, replace the other. Don't mix/match untouched with rebuilt/replaced, or else you'll experience a similar effect (because one will work much more efficiently than the other).
 
That's the only thing I didn't really have time to check. A worn/stuck piston may also explain the disappearing brake fluid if it's leaking past the piston ring. I'll have to check that out when I get some free time next week.
 
My truck had the same symptoms pulled to the right. When I rebuilt my front calipers I found that the left caliper had 2 seized pistons (little/no movement) and the rest were "gummy". I had to replace the 2 seized ones as I mangled them coming out, so I'd probably order at least 2 pistons before you tear into this (about $20 each). Slomo wrote a really good caliper rebuild thread. Check it out!
 
You know. I bet that is the problem. I took a closer look and it looks like the previous owner recently changed the brake lines on the front right side chasing the problem (or their mechanic), and there's also a box of new front OEM pads in the rear cargo area that they obviously forgot about. I'll pull that sucker apart next week and give it a good cleaning and refurb it. Hopefully that should fix it, because other than that the brake components look pretty new. Looks like someone put too much grease in that front right side too, grease was oozing out of the end cap, cleaned it up and put it back for now, will inspect further when I pull it all apart.
 
Like everyone already stated. Piston problem. Mine were so frozen I went with a reman instead of rebuilding myself. I still have a slight problem of the 80 pulling to the left but I think that is the nature of the beast when having a 8 1/2 lift.
 
Back
Top Bottom