Problem getting hub off

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 17, 2006
Threads
500
Messages
3,171
Location
Santa Rosa, CA
We've got the hub down this far

IMG_4980.webp


And it won't come off any more. It's hitting something quite solid. I can't figure out what it is and prying on it hasn't gotten us anywhere.

Ideas?
 
Yes - should have said that. But that's what it feels like - that the snap ring is still there. Move about 1/4" and won't go any farther.
 
Those are fj60 axles with 4x4 labs high steer and 6 bolt knuckles

Yes, I was worried one stud was bad.
Yes, the locking part came off easily - however, there were thread like bits of metal and this side is leaking axle oil.
 
Thanks - that worked. But there is a lot more play in the end of the axle shaft that I'd like to see. So, I guess we'll put it back together and this weekend tear it down again.
 
Thanks - that worked. But there is a lot more play in the end of the axle shaft that I'd like to see. So, I guess we'll put it back together and this weekend tear it down again.

You probably know that some play is entirely normal? Not sure on your level of experience, some people are surprised to see the axle flopping about a bit when the locking hub is removed..
 
This is my first time tearing down a birfield hub. And, I can spin the axle, like it's not connected to the differential. That's not right, is it? I think I snapped it last Rubicon. That means I went out Cadillac in 2 wheel drive.
 
This is my first time tearing down a birfield hub. And, I can spin the axle, like it's not connected to the differential. That's not right, is it? I think I snapped it last Rubicon. That means I went out Cadillac in 2 wheel drive.

If you lock the hub in on the other side, and put the transfer case in H4 and you can still spin the axle then, yep, there's major carnage.
 
This is my first time tearing down a birfield hub. And, I can spin the axle, like it's not connected to the differential. That's not right, is it? I think I snapped it last Rubicon. That means I went out Cadillac in 2 wheel drive.

is the differential open or locked?
 
It's got an ARB, but the ARB is open right now.
We are going to tear it down this afternoon and see what't going on. But I bet the Birf is blown up.
 
You can spin the axle, the spider gears just roll around the side gears, lock the other hub and see if it still spins ?
The cone washers are all out, yes ? The cone washers can leave a small burr or edge sometimes that the locking hub body will catch on, just tap it off. PM me your phone and I'll swing by and help out if you'd like. Done a few birf/axles, not a problem.
 
Okay, I was going to joke and that this looks fine

IMG_4981.webp


But then we got the parts out and saw this damage

IMG_4984.webp


That's part of the axle housing. How F**ked am I?
 
Jebus. Carnage indeed.

Did you not hear the clatter that must have made?

I'd start looking for new axle housing.
 
I went pop-pop-pop and it was done. No more noise.

We're going to try to grind the housing and see how it looks.
 
Back
Top Bottom