Power steering Leak

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 16, 2004
Threads
45
Messages
185
My power steering is leaking right where the steering colum shaft and the gear box meet.. Now I hae the bolt out of the knuckle and the shaft moves quite freely. The problem is that I can't get the power steering knuckle all the way off without the colum shaft getting in the way. It needs about 1/4inch more and the rubber between won't compress enough. How do I get that out of the way?

And where do i get a rebuild or a new gasket for it? In Canada?
 
nuclearlemon said:
how bad is the input seal? might try some lucas...it stopped my pump drive leak.

I tryed Lucas and it still was leaking. I took the top seal out and it looked alright but I am getting a new one anyways. Hopefully that will be the problem., If not looks like I will be dismantling the whole thing.
 
look very carefully at the shaft where it passes thru the seal for evidence of old rubber from the seal stuck to the shaft, pitting, or worst of all, a score in the shaft.

If it's just one of the first two, a light sanding with some emery cloth is in order. If it's scored, you might want to consider reinstalling the seal a little higher or lower so it doesn't ride on the scored part of the shaft.
 
65swb45 said:
look very carefully at the shaft where it passes thru the seal for evidence of old rubber from the seal stuck to the shaft, pitting, or worst of all, a score in the shaft.

If it's just one of the first two, a light sanding with some emery cloth is in order. If it's scored, you might want to consider reinstalling the seal a little higher or lower so it doesn't ride on the scored part of the shaft.

I looked at the shaft and it looks like there is some scoring done. Thanks for the idea about setting it higher or lower, but it screws done on so it might end up right back where it was.. How do I set it higher or lower?
 
Back
Top Bottom