Power steering for 350 conversion

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I’m running an fj80 (~FJ60) box and Saginaw pump. I’m still battling a leak from the pump, but that’s likely my wrenching ability more than anything else. It’ll push 35’s around with one finger. Not terrible install, but not bolt in either.
 
Mid 70's Scout PS
 
For those running a 350 conversion and stock steering column (I have a 68 FJ): What are you using for PS?

I had the stock steering when I dropped the 350 in my 70 FJ40 and memory says there was plenty of room.
A little later I put in PS with stock steering wheel and it was close, like a half inch, to the ram manifolds.
I originally used a sag from a 75 Chevy BelAir. There are two different ratios, can't remember the numbers, for the box but you want the one with the most turns lock to lock.
I set the steering box a little higher than most so the shaft is pretty close to the header.
This is not a good pic but if you look closely you can get an idea of the clearance from the bend on #2.
eng.webp
 
On my trail 40 yrs ago, the PO butchered a saginaw box out front, until the frame horns and frt crossmember couldn't take anymore. Now, updated to mid 70's Scout sag box with GM pump and newer frt cross member along with repaired frame horn.

The trail rig worked out so well, I'm now currently installing a Scout box on my street 40.
 
Last edited:
Saginaw with flaming river joints to save the original shaft. Put in a collapsible flaming river shaft just to be on the safe side.
 
Back
Top Bottom