Power steering cooler leak

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 3, 2008
Threads
49
Messages
300
Location
hampton, VA
Started my truck this morning, and heard a low groan/squeal that intensifies when I turn the steering wheel. I looked under the front of the truck and noticed something dripping. There appears to be a leak from the cooler tubing. There is considerable rust on the tubing. What are my replacement options, and how difficult a job is it?
 
Started my truck this morning, and heard a low groan/squeal that intensifies when I turn the steering wheel. I looked under the front of the truck and noticed something dripping. There appears to be a leak from the cooler tubing. There is considerable rust on the tubing. What are my replacement options, and how difficult a job is it?
What year truck?

May need to pull a hose and have a local hydraulic shop rebuild it.
 
If you mean the paper clip(tubing) get a used one from someone.
 
Yeah, that's the one. I think I may just replace it with a generic cooler. Probably replace the high pressure hose too.
Unless you push your 80 hard on demanding trails during hot weather and especially with bigger tires, you probably don’t need a cooler at all and could simply route a new low pressure hose from the steering box outlet back to the reservoir.

Power seeing fluid coolers haven’t always been installed at the factory on most 4x4’s and the “paper clip” cooler on an 80 barely enters the realm of fluid coolers anyway.
 
Last edited:
Unless you push your 80 hard on demanding trails during hot weather and especially with bigger tires, you probably don’t need a cooler at all and could simply route a new low pressure hose from the steering box outlet back to the reservoir.

Power seeing fluid coolers haven’t always been installed at the factory on most 4x4’s and the “paper clip” cooler on an 80 barely enters the realm of fluid coolers anyway.
Took your advice and bypassed the cooler. Thanks.
 
Took your advice and bypassed the cooler. Thanks.
You can easily verify the system temp with an infrared thermometer at the steering box and reservoir if you want some peace of mind.
 
If you mean the paper clip(tubing) get a used one from someone.
We are trying to track this down too.

When you say paper clip, I assume you mean this:

F26F6127-D380-4B39-A90C-C34F228338B2.webp


Sorry for the incomplete picture.

Note the active leak behind it. Went from damp yesterday night to actively dripping this am when backing the rig up. Still need to track this down more, but what else would be leaking in that area?

Thanks!
 
We are trying to track this down too.

When you say paper clip, I assume you mean this:

View attachment 3160794

Sorry for the incomplete picture.

Note the active leak behind it. Went from damp yesterday night to actively dripping this am when backing the rig up. Still need to track this down more, but what else would be leaking in that area?

Thanks!
Yes, the factory PS fluid cooler, aka paperclip
 
Being in NJ and seeing a bit of rust on the pipes, suspect a pin-hole leak in a pipe. Wash that area off and take more photos on the engine bay side of the hoses/pipes. It is hard to see as they're below the radiator partially hidden by the radiator fan cowl when looking down from above.
 
Back
Top Bottom