overdrive?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Something sounds fishy here. I've built and serviced several Fairey ODs over the years and one of the quirky things about them is that they ONLY fit over STOCK tranny tailshafts. So how on earth someone got one behind an SM420 in the first place is more than a mystery; it's pretty near impossible. Even the AA tailshafts, which are close to stock, are not close enough to put a Fairey on.

Like I said, somethin ain't right with this story.
 
Something sounds fishy here. I've built and serviced several Fairey ODs over the years and one of the quirky things about them is that they ONLY fit over STOCK tranny tailshafts. So how on earth someone got one behind an SM420 in the first place is more than a mystery; it's pretty near impossible. Even the AA tailshafts, which are close to stock, are not close enough to put a Fairey on.

Like I said, somethin ain't right with this story.

"ditto"
 
I was there in the flesh :) and it drove smooth. He's ran it for six years. He had done a bunch of machining work on the entire setup. According to him, the 420 is extremely similar to the 4 sp toy with the bolt placements and such. Isn't the fitting of the Fairey more about the TC anyway? At any rate, I don't think it was a hack job. His LC was very well setup with no cheap stuff. He had mini knuckles, lonfields, built 2f, onboard air, custom tied-in full cage, 37". This is why I had been considered buying the setup because it was a proven deal. The reason he wanted to sell the drivetrain? He built a buggy and no longer wheels his LC hard and wanted to go back to all Toyota for a DD
 
I have always wanted a fairley overdrive just to try it out. The problem is that you can't find them anywhere. It is not that they are great and worth every penny, it is just that they are rare.

The stock 3 speed tail shaft has a keyway machined in it that allowed the fairley to mount as far as I can remember reading. THis is also true for those Ramsey PTO units that bolt on to the back of the case.

The 420 does not from what I remember.

AA shafts also do not have a keyway.

Not sure?
 
I bought a 2f/4spd/4speed tc with a fairy bolted on the rear for my 74 fj40. The setup worked beautifully, no noises, but I lost the roll pin that holds the shift lever in place and got stuck in overdrive in the middle of a trail just before a hill that did not like my truck geared that high. Needless to say that was the last trail that setup ever saw. I got home and put the 3 sp tc in the next weekend. The IDEA of the overdrive was great, but in application for a truck that doesn't need to go more than 50 or 55 it is kind of useless.

As Poser said in the beginning of this thread it is a novelty. I might have considered keeping it if I used my truck more for the road. Now I have a hundred pound paper weight of mated tc and od sitting on my garage floor

As for the mounting of the overdrive unit. It does mount to the back of the transfer case, but the shaft on the unit slips over the transmission output shaft. So in order for the overdrive to fit on the tranny, the output shaft of the tranny would have to be the same as the overdrive.
 
Back
Top Bottom