OME851 and OME421?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 2, 2005
Threads
282
Messages
2,078
Location
CouleeDamWA, BoiseID
So I have a set of OME851's for the front. And OME N70 and N71E. Still waiting for the OME CC kit to come in this week I hope. I just need a set of rear springs. Another mudder might have a set of OME421's for the rear. I am unsure of this combo and wanted to ask others opinions.

The 80 is a daily driven family truck for my daughters and myself. But I also want to set it up for medium wheeling. With my TLE I cant do anything difficult or dangerous. So I am stuck at the back of the bus. Which isnt a bad thing I guess. Not like I've been out racking up the trail miles over the past 4 years. Anyway I'm setting this one up as the weekend warrior. Will later put on a non-winch ARB bullbar, keep the factory rear bumper maybe, and carry camping gear and supplies for my girls and myself. A set of sliders. Ready to go offroad when I want to, and thats pretty much how I do things anyway.

So would I be better off sticking with finding a good used and affordable set of OME860's? Or are these a good spring to go with to accomplish the same thing?
 
IMO you would be better off waiting to find the 860's, or just go ahead and order them new. Since you have sourced most of the parts you are only talking about a little difference on one set of coils. the 421's are the same free height as all the other ome rear springs but are close to the same spring rate as the 864's. With no weight in the rear and an arb for the front your truck will look like it is doing a handstand. you will probably want a spacer for the 851s even with the 860s. you might also consider just going to the low lift (862?) in the back.
 
851's are mediums you will want the 860s and the rear will still be high. I'm trading my 863s (heavy) for the 860s (medium) this weekend b/c I dont want to have to run a spacer and get into 4" territory.
 
IMO you would be better off waiting to find the 860's, or just go ahead and order them new. Since you have sourced most of the parts you are only talking about a little difference on one set of coils. the 421's are the same free height as all the other ome rear springs but are close to the same spring rate as the 864's. With no weight in the rear and an arb for the front your truck will look like it is doing a handstand. you will probably want a spacer for the 851s even with the 860s. you might also consider just going to the low lift (862?) in the back.

862's work great in the rear with the 851's. I have since added an ARB non-winch in the front, which really only dropped the front 1/4". I then added 20mm of packers in the front and another 10 in the rear. Sitting just how I like it:)

Original install: https://forum.ih8mud.com/80-series-tech/241701-hybrid-level-lift-done.html

Current Pic:

Front-2.jpg
 
Sent you a PM
 
Back
Top Bottom