OME comp vs Slee coils

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 7, 2006
Threads
57
Messages
457
Location
Orange, MA
Im running a FJ80 front axle in my Tacoma and I currently have the stock coils. Im going to be buying new lift springs. I was looking at the OME Competition 4 or 5 inch springs and the Slee 4 inch springs. I have read about the competition springs not being for rock crawling. Im looking for a spring that will handle the offroad abuse and not give too much body roll on the road. I know my ride will be different since the Tacoma is much lighter than the FJ80.
 
I don't have the knowledge to answer your question. I do know that folks will need to know what sort of weight (ie bumper, winch, dual batts etc) you have hangin off the front end so they can make an educted guess:D

Buck
 
I'd get OME J's if I were you, Slee and OME Comp springs will be way stiff on a Taco

Agreed. I just got the Comp springs and they're very stiff, even on the fat 80.
 
i just swapped out J's for 4''s and then mediums for the j's last night and can offer these observations. the J and the 4'' are the exact same length (height) out of the truck. the 4'' is thicker ( and about 25% stiffer) than the J spring. the mediums were 3/4 inch shorter than j's both w/ 9 coils per sping. appearing same diameter the J supposedly has a stiffer spring rate. do consider the weight of your taco, the j's might provide a bit better ride if your even concerned at this point. if you want crazy flexy ive seen rubicon express 5.5'' lift springs on a taco but it was rediculous how much it would flex.
 
since you're running a Taco which is significantly lighter I'd do a little looking around for some stock 80 springs that wer left over from a lift.

They would be next to nothing and would help you see how your truck compares to an 80 and would help you see where to go from there.

Thats what I have now. I need more lift so for bigger tires and so the lower links dont hit the TRE on full flex while turning. The stock coils are nice but when I welded the mounts onto the truck the coils compressed alot more than what was planned. I used a spring compressor and tighened down the coil with the impact and when it wouldnt go anymore I figured it would be about right for ride height but once the weight of the truck was on it they compressed alot more. The free height of the springs are about 21 inches and in the truck they are about 15. Im going to be building a front bumper and putting a winch on so the front will be weighted more. Are the J's about a 4 inch lift? Thats the minimum that I want for the lift.
 
the heavy non J springs from OME raise the 80 up about 2.5". I'd expect them on your truck to push it up even higher, might be around 4". The Js would definitely go over 4" I think.

I think I might go with the J's then. As long as the ride isnt to harsh and it flexes will thats all I want. Are the J's spring rate is less than the Slee 4"?
 
Back
Top Bottom