Oil Pressure

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Green Bean

SILVER Star
Joined
May 9, 2021
Threads
148
Messages
2,208
Location
Texas Coast
I wanted to verify that we were getting adequate oil pressure since the dash gauge is wonky. Installed a Tee fitting and hooked up a mechanical gauge. It looks like we're getting about 45 psi of oil pressure at idle. Is that within spec?
Thank you.

06.10.2021.Photo.1.webp
 
Well within spec. You could have as little as about 10 at hot idle and be fine.

Suggestion: Leave your gauge attached and get some hot and cold readings, perhaps at various engine speeds (idle and 2000 rpm), and write down this info (along with your oil viscosity). Years later, this is helpful if you suspect some sort of bearing issue.
 
Well within spec. You could have as little as about 10 at hot idle and be fine.

Suggestion: Leave your gauge attached and get some hot and cold readings, perhaps at various engine speeds (idle and 2000 rpm), and write down this info (along with your oil viscosity). Years later, this is helpful if you suspect some sort of bearing issue.
Steve: Thanks. I appreciate the help and great suggestions as well.
 
What Tee fitting did you use?
Engine:
I used McMaster-Carr 4443K835 Stainless Right Angle Adapter 1/8 BSPP female x 1/8 BSPP male. There were also various other fittings and adapters to go from BSPP to NPT. I'm sure there are probably more elegant ways but this is what worked for me. Let me know if you would like the complete list.
 
Back
Top Bottom