Oil press

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 27, 2006
Threads
70
Messages
589
Location
muuuuuud
I just got back from a 10hour round trip and usually my oil press will stay at half way when the oil is warmed up and im coasting around 70mph. On my way home noticed oil press started spiking to just under H mark. Anything I sould be worried about? This is on a 91 3fe
I have not changed the weight of the oil either.
 
At higher rpm's the oil pumps capacity exceeds the engines use of oil. For this reason the oil pump has a relief valve in it. The excess oil just dumps back into the pan.

I woud be more concern with no oil preassure than high, IMHO.

Also keep in mind that the preasure reading is transmitted by ele. signal. The gage could be going bad or an ele problem is in the mists.
 
Similar thing happened to me recently. While in the hills my gauge pegged. Everything seemed ok and I suspected a failing sending unit but then the next day it went to zero, no movement of the gauge. Checked manually and had like 5 psi. Replaced the oil pump and was good to go. Replaced sending unit while at it. Napa unit was either no good out of the box or wouldn't interface. Used OEM Toyota and everything was back to normal.
RandyS
 
I will keep a close look on the gauge see what happens, the gauge still seems to be working fine, ill just have to check it manually for the peice of mind Thanks
 
Back
Top Bottom