Oil level float sensor.... how touchy are they

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I don't like the idea of anything broken maybe floating around lose in my oil pan. So if it were me, I'd just buy a new sensor.
 
I don't like the idea of anything broken maybe floating around lose in my oil pan. So if it were me, I'd just buy a new sensor.
This. It's already broken but you have it removed. However much it costs I'm sure it's cheaper and easier than pulling everything apart again to replace it or worst case needing an engine rebuild because the piece blocked an oil passage.
 
the cost is
This. It's already broken but you have it removed. However much it costs I'm sure it's cheaper and easier than pulling everything apart again to replace it or worst case needing an engine rebuild because the piece blocked an oil passage.

Thanks for the reply.... thr discounted dealer cost of this part is around $325. can get salvage for less, but used is used. Thats my issue. if that little knick is not going to affect its operation, then id like to run it.
 
Personally, if I could get the part used I'd be good with it. Recently I cleaned mine up really well and reinstalled it with the original rubber seal plus a modest amount of FIPG.
 
ive got an ad in the classifieds, and the buggers are still expensive (best offer to my door is around 80$) ....thats gas and beer right there.
 
They are not critical, but handy, just an electric dip stick. Know of a few that have gone bad, they are disconnected, abandoned. The oil pickup has a screen, so relatively big stuff will not get sucked up, plus, that stuff should float, never get to the pickup.
 
Other option is to just take the rest of the black stuff off that is part of the float and put it back in and either jump the harness so the light is off or take the bulb out of the cluster. Then just check your oil on a more regular basis. Like others said it's not a critical part but I like having mine.
 
Thanks guys, actually the piece seems intact enough that I guess I'm not too concerned with it breaking apart. The corner just got snagged on either a rag or bumped something coming out.

I'm more concerned with it being off-balance and not working (moving properly) at the time I need it to. Id hate to bust an oil line or get a hole in my pan and not know it till my engine croaked.

I guess i could hook it up and dip it into a bucket of oil to make sure it works.
 
...
I'm more concerned with it being off-balance and not working (moving properly) at the time I need it to. Id hate to bust an oil line or get a hole in my pan and not know it till my engine croaked.
...

Most motors in history didn't come with an electric dip stick, and were successfully run long term. In case of oil pressure loss the gauge will indicate it. If it's not feasible to repair, just use the manual dip stick more often.
 
That will run fine. Mine looks just like it, look at it this way I've seen a couple broke just like that so you have already got rid of the weak part and now don't have to worry about a new used one breaking a chuck loose and something bad happening.
 
haha yeah, unfortunately when I work on a big job like this, I find little "weak spots" all over. (I pay my fair share of stupid tax ) I think ill try to run with it and if I have an issue I'll go from there. im sure glad i dropped my pan tho. my pickup screen was about 3/4 plugged with what looked like old gasket material.
 
Back
Top Bottom