I would be interested in 4 if there’s any left
Official ONSC member buying/selling thread (6 Viewers)
- Thread starter southerncruiser62
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Joined
- Jun 16, 2007
- Threads
- 24
- Messages
- 205
- Location
- Huntersville, NC
- Website
- www.charvoniadesign.com
Selling my 35x12.5x17 Ridge Grapplers on Fuel wheels - $1500
Under 2000 miles, set of five wheels and tires, balanced well, no cupping. The rear wheels and spare have had the hubs bored to 4.3” to fit over my rear hubs. Should not be an issue if you tighten the lugs by hand or get hub centric rings. 6x5.5 Currently on an ‘87 FJ60 Land Cruiser.
Under 2000 miles, set of five wheels and tires, balanced well, no cupping. The rear wheels and spare have had the hubs bored to 4.3” to fit over my rear hubs. Should not be an issue if you tighten the lugs by hand or get hub centric rings. 6x5.5 Currently on an ‘87 FJ60 Land Cruiser.
Green Hell Mustang
Designer, Hack Photographer
Vaper Orbital buffer
I have two bonnets that go with it. It's been used twice. I'm posting it here because I'm tired of dealing with idiots through Craigslist.
Price: Free
S4Cruiser
SILVER Star
How heavy is it? I was considering buying a Gem buffer for polishing the finish for a planned dining room table build. The Gem is ~16 pounds.
I'll take it. Need one to cut and polish moonshine's new paint.
Green Hell Mustang
Designer, Hack Photographer
This is definitely not a Gem. The buffer probably weighs about 2 or 3 lbs. I used to use a Gem when I worked at a detail shop, they are great. This has a plastic housing, I believe the Gem buffers all have cast aluminum housings. I will say that a lighter housing can be a benefit over a heavier one. When doing the side of a vehicle, heavier buffers will wear you down just trying to hold on to them. That was one of the things I enjoyed about this buffer, it's not as difficult to support as the Gem I used to use.
This buffer us about what you would expect to get at Sears or an auto supply place. It does the job and it won't burn through paint, though longevity probably leaves something to be desired over a Gem.
Yours for the low low price of free.
Green Hell Mustang
Designer, Hack Photographer
Sold! PM incoming.
cwags12
SILVER Star
ISO cheap 15" wheel and tire combo that will fit on the back of stock 40 series tire carrier. Condition not important. Let me know what you have.
I think I still have a factory 15" steel wheel from my 40 somewhere - pretty sure it's without a tire. LMK if you're interested and I'll try and find it.
RUNS AND DRIVES 1996 Toyota Tacoma 4wd 3.4 drivetrain. 3.4 V6 with 300k has new spark plug wires and spark plugs and coils, Auto transmission, chain drive t case. Motor runs great with plenty of power. no knocks or ticks. No smoke on start up. Comes with harness and computer. minus body harness. Take the whole truck for $650. Motor for $500 and trans and tcase for 250
cwags12
SILVER Star
Yes, thank you ! Feel free to PM me once you locate it.
Malleus
Far west of Siegen
auction of the week:
Fab shop auction
@GLTHFJ60 I know there's at least two things on the list you need.
Fab shop auction
@GLTHFJ60 I know there's at least two things on the list you need.
So, it turns out that the yakima towers were out in the shed reproducing...
I have no idea how I got so many
Between @southerncruiser62 @JohnVee and @AJR I think they are all spoken for. Ill hit you guys up via pm and update if any are still available.
I have no idea how I got so manyBetween @southerncruiser62 @JohnVee and @AJR I think they are all spoken for. Ill hit you guys up via pm and update if any are still available.
That’s quite an impressive collection. If I get 4 starters from you, how long will it take before my collection grows like that? Do they require and special feed, full sun, shade?So, it turns out that the yakima towers were out in the shed reproducing...
View attachment 2436957
Between @southerncruiser62 @JohnVee and @AJR I think they are all spoken for. Ill hit you guys up via pm and update if any are still available.
Puma 12v air compressor
$200
$200
WANTED: FJ60 driver front door in good shape. No rust, bondo, etc. Looking for one local in the Carolinas. Exhausted FB marketplace, ebay, craigslist, etc.
Thanks in advance!
Thanks in advance!
Hate to break it to you man, but they don't exist anymore.
I bought 4 here in Charlotte. 3 were great. Only 1 bad one. Still holding out hope.
I bought one driver front door from a guy in charlotte (not in the club). Paid $200 for a "rust free" door. Stripped the paint and found a corner rotted out through the front, and rust in every seam.
Maybe you could find some in the southwest, but not here, not for less than $500 a door. At that point it's cheaper to repair what you've got.
Maybe you could find some in the southwest, but not here, not for less than $500 a door. At that point it's cheaper to repair what you've got.
