Official ONSC member buying/selling thread

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Few things that I have:

1 stick (22' 3") of 1.75" 0.120" wall DOM tubing

1 stick (16' 4") of 1.5" 0.120 wall DOM tubing

$240 for both or $140 for the 1.75" stick and $100 for the 1.5" stick, obo



A brand new, never used Warn Roller fairlead from an m8000 winch, $40

5" front Allpro leaf springs for '79 to '85 Toyota trucks and '84 to '85 4runners, these will work with stock spring hangers $125

9- 15x7 aluminum factory Toyota wheels (6x5.5)-came on late 1st gen 4runners, 2nd gen 4runners, and '91-'92 80's, 5 have no wheels - $150 for a set of 4, 4 with worn out 31x10.50 tires-$200

Factory rollbar for an '84 to '89 Toyota 4runner, perfect condition, $60

2 -11" travel Rancho shocks, post on top eyelet on bottom, nearly brand new-have maybe 3 offroad rides on them-I went to longer shocks, these will fit the stock front shock towers on '84 and '85 toyota trucks and 4runners and possibly the earlier solid axle trucks, but I'm not positive about that, part number rs5234, cost $110 new - take $60 for the pair

Forward shift toyota transfer case, $75

Toyota 22re-head, block, intake manifold, valve cover, timing cover and chain, no exhaust manifold, no starter, no alternator, no injectors, no distributor, $300 OBO, motor is in a 1987 4x4 truck and ready to be removed, it was running when parked but had a bottom end knock

Smittybilt tube sidesteps for 1984 to 1989 Toyota 4runners, $50 for the pair

P30 Chevy Class A Motorhome chassis tracbar-Blue Ox Part number TT2300, I never even installed it. So it is basically new in box. $300

Everything OBO, Located in Auburn, AL, pm or email at

dragr at charter dot net
 
I have 2 brand new bridgestone insignia tires 205/55R16 tires for sale
Bought them for my wifes car and then she toatled it.

$160 for both... they retail about $120 each.

located in charlotte nc


I know many hondas, toyotas use this size as well as many mercedes (just not mine)
 
Adam, what happened to the 55 you were thinking about bidding on?
 
Did anyone in ONSC buy it?
 
*Pending Sale* Selling my 1976 FJ40 - I don't have the time, know how, or money at this point :). Need to get a down payment for a tractor - $3000.00 - hasn't been started since December. I won't be available to show until Wednesday - near Hickory NC, pm for actual location.

Engine has approx 5000 miles on rebuild (done prior to 2008, not by me -info provided by PO) --Crow RV grind cam, new bearings, pistons, rods, lifters, etc; Weber dual 38mm carb, dual Optima red tops (I have removed them as I put in a regular battery to troubleshoot - still have them and the tray is still setup for dual) and Hell Roaring Tech controller, electric fuel pump, HD four core radiator, high output GM alt, oil cooler, K&N air filter, MSD Offroad electronic ignition; driveline is sound--NV4500 (5 spd) mated to rebuilt Toyota 6 cylinder w/Advance Apapters kit, Advance Adapters Orion tcase (92:1 crawl in 4 low), manual lock wheels, e-brake pads replaced and longer cable installed after rebuild (longer tranny); driveline custom made by PHX Driveline b/c of longer NV4500 tranny. Has a ground issue (that's what I think - I am sure the pros here would confirm or say nay). Not trying to squeeze any extra cash - just need it gone and the money.

Vehicle comes w/ARBair locker and used LSD for axles (neither installed). Have some extras - partial transfer case, stock air cleaner, other misc parts, all included. Will take additional pics for anyone interested. Roll cage inside - hard top doesn't quite fit on top on passenger side due to roll cage.

Frame rust is surface rust only, no penetration/holes in frame or rear area.

Not trying to leave out any info - will answer any questions, thx all.

When I say not running since Dec - I don't mean to infer that it was a daily driver - it's had this electrical gremlin that I haven't been able to trace - the batteries run down within days if I don't keep hooked up to the battery charger - the turn signals don't work (I have a new turn signal assembly, not installed), etc. When it runs, I have no issues - I'd tool around town and such, but I wouldn't drive it anywhere far in it's condition - it'll smoke from the tailpipe when you first start it up, then clear up - I don't want anyone to think this is a creampuff... thx

enginedrvrside.webp


lftfrtdoor.webp


rear.webp
 
Last edited:
Back
Top Bottom