Now that I bought, what next?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 5, 2009
Threads
18
Messages
45
Fellas-

Just picked up my 97 Cruiser this past Friday. Truck is in great condition, with the exception of a CEL that decided to turn on during my drive home. Previous owner said that it comes and goes from time to time and needs to be "cleared"... was not a point of discussion when I was going through the buying process. He does not have to test for emissions, so never been a point of contention for him. Great guy, non the less...

Anyways, PO called his wrench and said it should not be an issue to get pass emissions and should be able to clear the code; however, will continue to pop up over time. Apparently it has something to do with the emissions control computer...or some sort of "ERG" valve. Do forgive my ignorance, as I am new to the 80...:flipoff2:

Question to the forum, with the exception of the emissions issue that will need to addressed tomorrow, please let me know of any additional "need to do" items you could think of while the truck is at the shop. Obviously trying to identify any basic PM, not elaborate mods..Trying to get a good baseline. So far, the PO has maintained up until this point:


  • Front and rear diffs- serviced when 4.88 gears installed-approx 100,000
  • Trans fluid change 75,000;
  • Plugs,wires,O2 sensors 75,000;air filter 105,000;
  • engine oil and filters120,500;
  • front axle universals( birfields) 75,000
No issues with compression or Head Gasket, per the PO.

The truck is a 97 40th Edition w/ 122k. Has lockers, 2.5 medium OME, ARB, 295's BFG A/T, 4.88 gears, 9000 lb warn, and very very clean....

Love the truck. Been looking for 3-4 months and found this one- was meant to be. Great forum with tons of info. I am sure that I will get some great use out of the search function.

Appreciate the help in advance. Once I get her all cleaned up, will post some porn.
 
Last edited:
Congratulations and welcome. I just got my first 80 a week ago (although I have been lusting after them for years).

As you have probably seen, the Check Engine Light (CEL) comes up regularly. Some people ignore it, others try to fix it with varying degrees of success. Most autoparts stores will read and clear codes for you if you don't want to spend $100 on a code reader. Many jurisdictions won't let a vehicle pass emissions if there is a CEL on. So some clear it before they test it and others fix the underlying problem. There is no single solution as there are a variety of things that throw codes - even the same code, such as EGR (Exhaust Gas Return/Recirculation). First things first is to find out exactly what the codes is to help you diagnose the problem. You can then search here by the actual code and finds lots of info.

It sounds like it was maintained well and you plan to keep up with the PM. There is a thread about cheap mods you may want to check out. Cupholders may be a good idea . . . I just installed two 12V accessory outlets in the back of the center console and plan to add some more since there is only the cigarette lighter stock.
 
Welcome.
There are a lot of little PM items to do. Search the FAQ and rest of the 80's forum and and you will find a bunch of threads with recommendations.
 
Last edited:
Thanks for the reply and warm welcome. I will check up on the low cost mod thread.

Here is a recent photo from the seller.
Cruzer 1.webp
 
I saw that one for sale but it looked like it had a mirror in the middle of the drivers door. It was for sale in Georgia right?
 
That is fine looking rig, congrats. When you get the CEL code cleared, be sure to get the actual code from the tech, such as "PO401" and not the verbal explanation such as "emissions control". You can search with the actual code and find all you need. You can also buy a ScanGuage and clear your own codes.
 
Welcome to mud and congrats on a good start on a great rig.

what next??? Hide your wallet :D seriously

Like mike mentions above get the actual code and research from there. There is a lot of info on this board about the EGR system and tests and fixes that folks have done. Mine turned out to be the vaccuum modulator, quick and easy fix and havent had a CEL since then.

Definately purchase an FSM if you havent already and youll be able to help yourself and save some $
 
You can have the code read at most of the bog autoparts chain stores, for free. You may have trouble getting past emissions testing even after the codes are cleared, the ECU has to go through some specific driving conditions before it reports the monitors are "ready". I have an intermittent EGR code, sometimes it is months between turning on, I will need to fix it one day, and there is plenty of info in the forum for the different codes.
 
Back
Top Bottom