No Cruise Control

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 23, 2005
Threads
75
Messages
3,365
Location
Oregon
Just bought a "new" '95 FZJ80 and was surprised to find out on the drive home that the cruise control does not work. The dash light comes on when I turn it on but I can't set it.

I've run the diagnostics as outlined in this thread:

Cruise control issue

It appears that it passes all the diagnostics and the light flashes correctly for each of the tests outlined in that post. However, still no cruise control. Ideas?
 
Last edited:
Is the cable hooked up at either end? Broken in the middle or seized up? Is it adjusted just right?
 
Brake fluid reservoir cap.
The sensor in the cap can go intermittent causing the dash BRAKE warning lamp to dimly illuminate. This will prevent CC from setting a speed.
A quick test is to simply disconnect the sensor in the cap and see if all your dreams have come true.
 
The brake pedal switch set to sensitive does disable the CC. Heard about the brake fluid being low causing a problem, some vehicles CC is linked to the handbrake as well.

Regards

Dave
 
Brake fluid reservoir cap.
The sensor in the cap can go intermittent causing the dash BRAKE warning lamp to dimly illuminate. This will prevent CC from setting a speed.
A quick test is to simply disconnect the sensor in the cap and see if all your dreams have come true.

Interesting! The rig came with the cap sensor disconnected. However, the cruise control did not work. I plugged it back in and it now the brake warning lamp dimly glows, just like you said. So it looks like the sensor in the cap is bad. However, unplugged it CC still does not work. Too much of a coincidence though.

Does anyone know if the cap from my '93 will fit on this '95? The cruise control works fine on the '93.
 
Interesting! The rig came with the cap sensor disconnected. However, the cruise control did not work. I plugged it back in and it now the brake warning lamp dimly glows, just like you said. So it looks like the sensor in the cap is bad. However, unplugged it CC still does not work. Too much of a coincidence though.

Does anyone know if the cap from my '93 will fit on this '95? The cruise control works fine on the '93.
If the CC doesn't set when the cap is disconnected, then it can't be that part of the circuit. The cap needs to be replaced in any case and I'm pretty sure they're interchangeable between all years.
Anything that will affect the BRAKE lamp circuit will cancel CC. If the CC system passed all the FSM tests, then it has to be from an external circuit.
 
Make sure there is enough brake fluid in the reservoir to keep the BRAKE light from coming on also.

However, my 96 cruise has worked fine for 8 months driving with the BRAKE light on due to low fluid. So I know it does NOT typically disable the cruise, as mine has been working fine.
 
Well, my '93 does not have the switch in the cap, so no debugging last night. Looks like I'll have to go borrow a friends cap to see if that fixes it. And the reservoir is full.
 
Well, my '93 does not have the switch in the cap, so no debugging last night. Looks like I'll have to go borrow a friends cap to see if that fixes it. And the reservoir is full.
That doesn't sound right. It has to have a low brake fluid sensor and I can't see Toyota changing this design considering both my 91 and 97 have it. Is there another float in the reservoir?
 
Didn't really look that close. I got the hood open and saw there there were no wires attached to the cap on the '93 and closed the hood. Went over to my friends where there is a parts rig that happens to also be a '95. I swapped reservoir caps. Good news is that the brake light no longer faintly glows. The bad news is that it didn't fix the cruiser control. Any more ideas?
 
cant you just jump the connector? The switch just closes with the float.
 
That doesn't sound right. It has to have a low brake fluid sensor and I can't see Toyota changing this design considering both my 91 and 97 have it. Is there another float in the reservoir?

My 94 has no sensor on the cap but it does have a senor on the inboard side of the fluid reservoir. Just another reason the 93&94 are far superior to all other model years.
 
Do you have an aftermarket trailer light harness that gets its input from the rear taillights? This messed with mine. I dont tow with it, so I removed it and now I have CC again.
 
My 94 has no sensor on the cap but it does have a senor on the inboard side of the fluid reservoir. Just another reason the 93&94 are far superior to all other model years.
Well then I stand corrected. I guess that Toyota did change the design for the 93/94 brake fluid level sensor.
 
Didn't really look that close. I got the hood open and saw there there were no wires attached to the cap on the '93 and closed the hood. Went over to my friends where there is a parts rig that happens to also be a '95. I swapped reservoir caps. Good news is that the brake light no longer faintly glows. The bad news is that it didn't fix the cruiser control. Any more ideas?
Well, we already knew that the cap wasn't the issue because it was disconnected. See post #7.
Again, anything that affects the brake lamp circuit will cancel CC.
On my 97 I have a flat 4 trailer harness with one of those LED covers. After the most recent snow/road salt barrage, I found out that my CC would cancel with my headlights. Apparently salt water got into the cap and was shorting out. As soon as I unplugged the LED cap, all was well. Cleaned it all out with some WD40 and compressed air.
 
08E98B80-9D5B-4E87-963E-61971F43063A.webp
My 94 has no sensor on the cap but it does have a senor on the inboard side of the fluid reservoir. Just another reason the 93&94 are far superior to all other model years.

Too much tech and useful information...must troll!
 
OK. I don't drive this rig much but I did drive it to work today so I could stop at the DMV to transfer the title. So, on my way to work I tried yjr cruiser control and the damn thing worked. I thought awesome. It works. So on the way home, I tried it again. Not only didn't it work, but after playing with pushing the lever up and down a few times, not only didn't it work, but the CRUISE light on the dash went out and no amount of end button pushing or lever pushing could get the dash light on again. It would not come on again until I turned off the vehicle and restarted the engine. Like I had to reboot the cruise control. Ideas?
 
Back
Top Bottom