Newbie gear question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 23, 2005
Threads
10
Messages
21
Location
marietta, GA
I am lifting my '79 40 and plan to put 33 in mtrs on it. Is that too big for my gear ratio? I do some mild-medium wheelin.
 
I have 33" SSRs on my 79

It can handle it no problem, but it would be much happier with 4.10's

I definately noticed a slight loss in power when I went from 31" AT's to the 33" swampers
 
if you find some earlier thirdmembers it wouldn't be all that expensive to go to 4.10, if you want lower gears the shop that did my work charges about 500 per axle for a R&P (yukon brand) and benchtop installation ie. I bring in loose thirdmembers. so about $1000 for just gears, I think the $ would be better spent towards a doubler box or a sm420 or sm465 transmission. Wish I would have gone that route and still plan to do a sm465 to rockbox to 4spd case combo with a 4.3 vortec.
HTH
 
Now is the time to decide if you wanna add a locker or two. Put both your 3.70 geared 3rd members in the for sale section. Then, if you wanna go with 4.10's, look for a pair of '78 3rd's from a 40 or from an FJ62. If you plan on adding lockers, give Mike Curtis (East Hiram 4x4) a call 770-943-7948. He setup all my axles (D60's too) with Detroits & ARB's. His shop is about 15 miles outside Marietta. Good luck!
 
Last edited:
What would be the best way to make up for the loss of power with the bigger tires and lift?
 
Since you have the 79+ gear ratio of 3.7, a swap to a set of good used 4.10's out of an earlier truck or FJ62 would help out.

There are also multiple tranny swaps possible for a lower first gear. (SM420, SM465, Toyota H41)

Search and look in tech and you will find lots of information.

You will be fine with 33's, with 4.10's you could run 35's or have more low end with a set of 33's.
 
I had 4.11 gears and when I went to 35" tires with my stock 3 speed I wasn't geared low enough. I spent the money to go with 4:88 gears. Rather expensive. Then I swapped out my Transmission with an SM465. Just wheeled it this weekend in Moab and Love the new granny gear. In my opinion the tranny swap would be better than the gear option.

Troy
 
CruisinGA said:
There are also multiple tranny swaps possible for a lower first gear. (SM420, SM465, Toyota H41)
Isn't the H41 tranny the 3.55:1 ratio that I have in my '78?
I've been told that I need the H42 if I want a lower 1st gear. It is supposed to have something like 4.9:1. Or I need to pick up a 5spd
 
the H41 is the non-usa 4 speed with the 4.99 : 1 1st gear
the H42 is the USA 4 speed with the 3.55 : 1 1st gear
the H55 is the non-usa 5 speed... this is an H41 with OD
 
rogersfj401969 said:
the H41 is the non-usa 4 speed with the 4.99 : 1 1st gear
the H42 is the USA 4 speed with the 3.55 : 1 1st gear
the H55 is the non-usa 5 speed... this is an H41 with OD

Somebody's been doing their homework! Still not an A student. The H55 ratios are close to an H41, but not exact.

You should really fine tune your truck incrementally. Get the tires first, and find out if you are going to be happy with them sizewise. Then, decide what kind of wheeling you are going to be doing and what kind of street mileage and performance you can live with if you modify further. If tire size is ok, I'd leave the pumpkins alone and go for a tranny awap first. I would only do gears first if you are losing highway speed because of the tires. My .02
 
If you do Ring and Pinions they are going to cost at least ~$600 just for gears and bearings

If you do used 3rd members with 4.10's it will be cheaper (if you can find em)

A H41 costs around $600 plus shipping

I would either leave it alone or swap in 4.10's

Regearing is the best way to make up the lost power, there isn't a whole lot to do to a 2F to get the power back for the money gears cost

Save your money and buy an Orion, that way you have high gears for the highway, and low gears for the trail
 
I agree on the orion option. I have a 79 with 3.70's and 33's. It's great on the highway, I can run 75mph easily with traffic. But off road it's definately not quite low enough in some of the rough stuff. It's fine for the light wheeling I do locally. But I hope to someday run the rubicon and spend some time in moab. For that, an orion would be great. Still have the same highway manners, still have the nice shifting 4 speed, and have a nice low range.
 
I've got front and rear thirds complete w/ 4.10's out of a 69' FJ40 I'll be willing to get rid of. They are my trail spares :bounce: . Pm me if ya interested.
Campy
 
I've got an H41 (first gear is 4.93:1, btw :)) with stock 4:10s and first gear pulls 35" tires easily. It's a good gear in low range but in high range I sometimes wonder why it's there. If I do it over I think that I'd stick with the stock H42 and bite the bullet for an Orion transfercase that leaves the high range stock while giving all four gears in low range a 4:1 reduction(!!) If the Orion holds up (my big question right now) then it's the best overall setup I know of.
 
Back
Top Bottom