Need some advice...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

I wanna thank aggiepaintrain. He ran the VIN, there has been only 2 owners, and the LC has spent it's life here in AZ. There were two reported accidents as well. And only 2 owners.
 
Last edited:
Here is another local LC I just found not too far from here. I found this 1994 not too far away from me. It does have 10K more miles, the exterior looks to be in better shape with the exception of the faded paint (Doing Monstaliner).

He is asking a little out of my price range and I told him all I could do, but I mentioned I am a veteran and he said if I could come up a little more he would work with me.

qc1994.webp


IMG_0151.webp


IMG_0152.webp
 
Last edited:
Is this your experience with a rear Aussie locked 80? Have a Harrop up front in mine and an Aussie sitting on the shelf ready to go in the rear. Been in two rear Aussie locked 80s and never experienced the rear walking out. Not sure I want to install mine if this is a common issue...

Lockers are great, can save your bacon, but can also get you in trouble. One example would be, off-camber, slippery, climbing turn, so throttle is needed, if/when traction is lost it can crab walk, more throttle, more crab walk, not a place you want to be locked. One of the compromises of the auto-locker, cant unlock.

With any equipment, best to play with it, in as many conditions as possible, so you know what to expect, how to react. In this case, rolling through with a little more speed, being light on the throttle/smooth as possible, not stopping, works. But best to find this out before being on that narrow shelf road! :hillbilly:
 
I understand how lockers are beneficial. But a 3x locked LC is out of my price range, but is a modification I wanna make down the road.

I am not sure which locker I wanna go with ARB or another manufacturer. Each one brings something different to the table. I am leaning towards ARB as I like their compressor with dual outputs. Like the idea of that dual outlet, less work in the summer and less likely to overheat.
 
The great thing about AZ is that there will be no rust on the vehicle. I’m amazed that you found two rigs with clothe interior in a place where 80’s are scarce. In my opinion, clothe is the only way to go not to mention it has held up much better over the years than leather.

I wouldn’t be concerned about paint because that can be remedied cheaply with Monstaliner or spray cans unless your need to have a princess perfect show quality paint job.

These trucks are getting old and even though they were built well, refurbishment will be necessary, there is no way around that unless you buy one that’s already been restored and then you pay for it up front.
 
As @CaptClose said, I'd add up the total cost of acquisition (purchase, baseline, repairs) of both rigs and see what would be the better deal in the near and long term. Maybe ask the second owner if he will take something in trade to bring the price into your budget.

The second one doesn't look to have been hit like the first. Even if you aren't worried about cosmetics right now, when you do decide to fix the first one there will be a cost in time and $. The time might be yours or more $ for someone else to fix based on your skillset and toolset.

Both are 20+ y/o vehicles, 10k difference in mileage in NBD. Buy the best one you can afford, be ready for the unexpected repairs and continuously set aside $ when you find an issue that must be repaired.

Side note: As @baldilocks said, you have an uncanny ability to find cloth interiors. When you sniff out a set of front row in tan, drop me a PM and I'll pay you a finders fee.

FWIW, and a total internet assessment, but I like the second one you found. Good luck with your search.
 
The great thing about AZ is that there will be no rust on the vehicle. I’m amazed that you found two rigs with clothe interior in a place where 80’s are scarce. In my opinion, clothe is the only way to go not to mention it has held up much better over the years than leather.

I wouldn’t be concerned about paint because that can be remedied cheaply with Monstaliner or spray cans unless your need to have a princess perfect show quality paint job.

These trucks are getting old and even though they were built well, refurbishment will be necessary, there is no way around that unless you buy one that’s already been restored and then you pay for it up front.

Especially in the condition that both are in for being 24-25 years old and the sun doesn't help. The drivers seat on my 06 Xterra has bolster wear, the 2nd LC looks like the foam has broken down but not the cloth of the seat.

The 2nd LC was a NV/AZ car and two owners have been reported to DMV and CarFax is reporting that. The 2nd one in my opinion is a better deal and a couple hundred more then what then the first LC.

2nd LC has at least 24 reported maintenance events, no accidents, average of 9250 miles annually, paint in better condition but still faded (expected in the AZ sun), working A/C, and no major issues I am aware of but will check it later today. But does have a power steering leak that the seller revealed in the ad.

1st LC issues are faded paint, warped right front rotor, NO A/C, window regulator issues, dry rotted tires, 2 accidents (front impact/sideswipe), 1 maintenance record according to CarFax.

If I can get the 2nd LC for closer to my budget I will more then likely go with it. Time is a factor now...
 
As @CaptClose said, I'd add up the total cost of acquisition (purchase, baseline, repairs) of both rigs and see what would be the better deal in the near and long term. Maybe ask the second owner if he will take something in trade to bring the price into your budget.

The second one doesn't look to have been hit like the first. Even if you aren't worried about cosmetics right now, when you do decide to fix the first one there will be a cost in time and $. The time might be yours or more $ for someone else to fix based on your skillset and toolset.

Both are 20+ y/o vehicles, 10k difference in mileage in NBD. Buy the best one you can afford, be ready for the unexpected repairs and continuously set aside $ when you find an issue that must be repaired.

Side note: As @baldilocks said, you have an uncanny ability to find cloth interiors. When you sniff out a set of front row in tan, drop me a PM and I'll pay you a finders fee.

FWIW, and a total internet assessment, but I like the second one you found. Good luck with your search.

When you posted this I was writing up a post as well. I am really leaning towards the 2nd one. It is a better deal in my mind and the vehicle history is a lot better, but that all could change after I look at the rig later today.

Are you just looking for seats or another LC with tan interior?
 
I understand how lockers are beneficial. But a 3x locked LC is out of my price range, but is a modification I wanna make down the road.

I am not sure which locker I wanna go with ARB or another manufacturer. Each one brings something different to the table. I am leaning towards ARB as I like their compressor with dual outputs. Like the idea of that dual outlet, less work in the summer and less likely to overheat.

Food for thought: Do a York OBA first. It'll air you and your buddies up in less time than an electric compressor, you can run air tools off it (if you use the 210 compressor), and it will give you the air for the ARB down the road.

As for the lockers themselves... ARB has proven itself over the decades, but you do hear about air leaks from time to time. I've yet to hear about an air leak from a Harrop, though. No matter which way you go, if you're new to wheeling, don't worry about lockers for a while. Suspension travel and being able to read the trail will go a long way towards making it through stuff you think you'd need a locker for. If you have a locker off the hop, you get lazy because, eh... just push the button and motor over whatever's in your way.

Enjoy the ride!
 
Forget the 1st one, I like the 2nd one as well.

I am really liking the 2nd one too. You seen the two CarFax reports and I get a better feeling from the 2nd report.
 
The second one is closer to being ready to go, at least from a body perspective. I wouldn't worry about the miles, just go by condition.

Mileage really has never been a concern of all the cars I ever bought. If the seller can provide documentation of said maintenance and you continue that trend a car will last forever.
 
[QUOTE="OffRoadScott, post: 11630285, member: 102502"Are you just looking for seats or another LC with tan interior?[/QUOTE]

Just seats, I only require one money pit at a time.
 
[QUOTE="OffRoadScott, post: 11630285, member: 102502"Are you just looking for seats or another LC with tan interior?

Just seats, I only require one money pit at a time.[/QUOTE]

Okay I will see what I can find.
 
So I went and drove the 2nd LC today. It is a lot better then the first one, working AC (cold), no brake issues, doesn't lag on acceleration and the body is in better shape. The paint is faded on both, the interior is good shape on both.

When I drove the 2nd LC I wanted to make sure the transfer case worked. So I stopped dropped it into Neutral and shifted into "L". The gearing in low is nuts. I was lightly on the brake pedal and when I shifted into "D" it started to pull away on it's own. The ECT light works not sure if it was locking the center diff. I will have some of the local guys check it out when/if I bring it home and tell me if it is working.

One thing that I did notice was that under load on start up the belts slipped but that is an easy fix and looks like the valve cover gasket and distributor gasket both leak.

I have a few videos of the LC from when it was at the gas station and then under idle.
 
So I went and drove the 2nd LC today. It is a lot better then the first one, working AC (cold), no brake issues, doesn't lag on acceleration and the body is in better shape. The paint is faded on both, the interior is good shape on both.

When I drove the 2nd LC I wanted to make sure the transfer case worked. So I stopped dropped it into Neutral and shifted into "L". The gearing in low is nuts. I was lightly on the brake pedal and when I shifted into "D" it started to pull away on it's own. The ECT light works not sure if it was locking the center diff. I will have some of the local guys check it out when/if I bring it home and tell me if it is working.

One thing that I did notice was that under load on start up the belts slipped but that is an easy fix and looks like the valve cover gasket and distributor gasket both leak.

I have a few videos of the LC from when it was at the gas station and then under idle.


The second one sounds like a winner. Pretty sure the ECT button has nothing to do with the center lock, it makes the trans shift at different points. It's a little peppier when it is engaged, but I suspect it burns even more gas when it's in that mode so I don't use it. It locks the center as soon as you shift into low.

The belts and leaks are going to be standard baselining projects.

So did you buy it? If not, why not? In your price range, that is a good buy.
 
As Tools said, our shop is not very far away, drop by and chat a whenever. We wheel often and there are usually open seats available. It would give you a chance to see multiple 80s with various setups on the trails. The Tonto is utterly amazing with 3,000,000 acres and 3500 MILES of trails: everything from light touring to OMG Drama/Trama!
 
The second one sounds like a winner. Pretty sure the ECT button has nothing to do with the center lock, it makes the trans shift at different points. It's a little peppier when it is engaged, but I suspect it burns even more gas when it's in that mode so I don't use it. It locks the center as soon as you shift into low.

The belts and leaks are going to be standard baselining projects.

So did you buy it? If not, why not? In your price range, that is a good buy.

Okay I was not sure what the ECT button actually did. So it can be engaged in "H" or "L"? I made an offer and am just waiting to hear back from him. He said there is a really good chance he will accept but not going to hold my breath.
 
Back
Top Bottom