Need Help with the Last Wire

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 24, 2015
Threads
117
Messages
336
Location
Clarksville, TN 37043
I’ve reinstalled and connected the wiring harnesses in my 79 FJ40 and I’m left with a single wire that I don’t know what it connects to.

It is a thin black wire with a white stripe and has a single terminal connector on the end. Given its color I think it is a ground wire, but I’m baffled by the terminal on the end of it. The wire/terminal is on the business end of the alternator harness.

If it helps it is a Nippondenso 27060-61010 alternator.

If you know what this wire connects I’d like to hear from you and as always, a picture is helpful.

Thanks

upload_2018-9-13_20-5-2.webp


upload_2018-9-13_20-5-27.webp


upload_2018-9-13_20-6-4.webp
 
I’ve reinstalled and connected the wiring harnesses in my 79 FJ40 and I’m left with a single wire that I don’t know what it connects to.

It is a thin black wire with a white stripe and has a single terminal connector on the end. Given its color I think it is a ground wire, but I’m baffled by the terminal on the end of it. The wire/terminal is on the business end of the alternator harness.

If it helps it is a Nippondenso 27060-61010 alternator.

If you know what this wire connects I’d like to hear from you and as always, a picture is helpful.

Thanks

View attachment 1788896

View attachment 1788898

View attachment 1788899



That wire is NOT a ground wire , White wires with black tracer stripes are ground wires


i have come across this before but dont recall , @Living in the Past will know exactly what that wire goes to
 
Just checked my Haynes wiring diagram for 79. There is black with white stripe wire that goes to the A/C pressure switch with appears to have a short wire without a color noted to the compressor clutch. Paul @3_puppies seems to have nailed what it is for. The pressure switch is by the compressor which is by the alternator. In this location makes sense.
 
3_puppies & Living in the Past

Thanks guys. With your info I found what you were referencing on my wiring diagrams. Seems like it's for an non-existent magnetic clutch.
I also learned from studying the diagrams that a air conditioner in Toyota speak is a Cooler Unit.
 
The wire actually went to a non-existent pressure switch that had two connections. One was the black with white stripe out of the harness the other would be the one going to the non-existent compressor clutch. That wire has no color noted on Haynes manual. Did you look for a plug under the dash that would have gone to the A/C control box under the dash. You might also have the correct duct between the blower and heater when A/C is installed. The battery mount would be different as well. Would also have a spot where the refrigerant line went to the evaporator under the dash. It would be a shame if you have that duct and battery mount used without a A/C. Sure you could trade those for non-A/C parts plus cash. I know I would be interested.
 
Below is a page from one of the wiring diagrams I have that show black and white wires going to both the pressure switch and the magnetic clutch. At this point I'm now convinced that the wire I was worried about, was not connected to anything when I removed the harness.

I've also included pictures of the duct work under the dash and the rear heater. As for the battery mount there doesn't seem to be anything special about it.

I've never seen a factory installed AC in a FJ40 but I'm reasonably sure mine never had it. There were no AC switches on the dash but perhaps Toyota had the related controls on the unit.

Again thanks for the help

upload_2018-9-18_17-57-38.webp



upload_2018-9-18_17-58-2.webp


upload_2018-9-18_17-58-22.webp
 
Nice looking cruiser. That is the normal duct between the blower and heater. Would if a mistake was made and wrong harness was installed. You didn't find a extra plug in the harness to the left of the heater?


The Haynes manual has wiring schematic not just a diagram. Schematics show how it works verses diagram that doesn't show much more than general location and wire color.
 
S.CarolinaFZJ80

First, Hope you and all your love ones are safe and dry including that 79 FJ40.

I'm jealous of your AC. As I noted earlier in this thread I haven't seen a FJ40 with factory air. Is the compressor mounted on the same bracket that the alternator is on?

When you have time could you post a picture or two of what the AC unit looks like inside the cabin.

Thanks

tom
 
S.CarolinaFZJ80

First, Hope you and all your love ones are safe and dry including that 79 FJ40.

I'm jealous of your AC. As I noted earlier in this thread I haven't seen a FJ40 with factory air. Is the compressor mounted on the same bracket that the alternator is on?

When you have time could you post a picture or two of what the AC unit looks like inside the cabin.

Thanks

tom
Thanks. We are fine but others to the east didn’t fare so well.
I’d be happy to take some pictures for you.
 
Last edited:
the a/c compressor pivots on the motor mount and is tensioned off a bracket attached under the alternator bracket.
same setup on 60 series 2F
 
the a/c compressor pivots on the motor mount and is tensioned off a bracket attached under the alternator bracket.
same setup on 60 series 2F

So tell me Paul what would it take to add a 60 series compressor to a 79 2F? Assume the battery mount would need to move back. My 79 had a York compressor when I bought and think the mount was already modified. Does it require a special motor mount front right? Not sure any bolts were in the motor mount to engine when I bought it.:eek:
 
AFAIK you can use the 60 motor mount and compressor, I thought someone mentioned the 40 compressor was shorter but haven't measured it. I can if I remember. Only clearance issue would be the battery mount.

the 60 mount is the same as the 40 mount, @65swb45 had a different looking mount posted before, but the one on my 1980 sure looks the same as a 60.
 
Back
Top Bottom