need help with locker selection ?? AUburn??

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 24, 2006
Threads
53
Messages
259
Location
Alabama
Website
www.auburn.edu
I am looking at getting a auburn limites slip for rear and something the front for my 77 fj40 40% on pavement 30% dirt 15% mud area and rest crawling:: spring over running 37s and about to change to 4.88. stock in6, tranny, and t case what advice you have for locker and gears?? auburn a good way to go??
 
ARB IF YOU CAN SWING THE $$$$... IF NOT THEN AUSSIE IS THE WAY TO GO, FROM WHAT I'VE READ AND BEEN TOLD ...

JUST MY .02 WORTH..


GOOD LUCK .. :cheers:
 
The Auburn will not work for crap with 37's.

It sure hates my 38's. Loved the 34x9.5's, however.

Aussie is almost half of what an Auburn is. ARB in front if you can do it.
 
No they do not.
 
chajazz said:
so any cable lockers out there worth it?




OEM units are nice....if you can find them in a complete axle assembly already, so you do not need to try and source the oddball axle shaft needed to make it operate properly...





You are aware of the differences in a locking diff and an Auburn or other limited slip affair correct?
 
ditto

FJ40 MNTCRZR said:
ARB IF YOU CAN SWING THE $$$$... IF NOT THEN AUSSIE IS THE WAY TO GO, FROM WHAT I'VE READ AND BEEN TOLD ...

JUST MY .02 WORTH..


GOOD LUCK .. :cheers:

ARB (if $ is not an issue) or Aussie locker without questions
 
I had the same question about a month ago, and I decided to go with aussie, $250 well spent, havent installed them yet, but, anyway! I'm happy with them
Anyway, if you install them on front, you dissengage everything whith the lockout hubs, and wont have problems on street, maybe it would be a little difficult turning when you have the 4wd engaged, but, I decided that its worth it!
 
Back
Top Bottom