Need Help - Transmission Problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 16, 2016
Threads
1
Messages
4
Location
BC Canada
1992 80 series RHD with the A442F. Went to put it in reverse today and had no reverse at all. Tried forward and had no forward gears either. I turned it off and immediately back on and had all gears back again. This lasted for a few miles and while traveling in drive it seemed like the transmission "disconnected" again. Shut it off and turn it back on and good to go again. It got worse and worse until I made it home.

Oil level is good, oil is newish and clean. Tranny never slipped previously and never overheated.

Thoughts? Is this a mechanical or electrical problem? Thanks in advance for any help
 
If it is an A442F that does sound like a solenoid problem.
But here's the list from the FSM for no forward or reverse gear:

Manual linkage out of adjustment

Valve body or primary regulator faulty

Parking lock pawl faulty

Torque converter faulty

Converter drive plate broken

Oil pump intake screen blocked

Transmission faulty
 
Last edited:
Thanks all, i will do a few more checks, I was thinking electronics due to the intermittent nature. I did try the CDL with no luck.
 
The A442f will actually function without any electricity. If it looses electrical power you have to manually select the gear i.e. D engages 4th (and only 4th), 2 engages 2nd and 1 engages first. Basically it becomes a manual without a clutch pedal. Your problem doesn't sound electrical, hopefully its something simple like the shift linkage.
 
Screams fluid level to me.
Transmission fluid level has to be checked at normal operating temp, with the engine running, after cycling through all the gears and back to park. Fluid level should be at the HOT mark.
Not sure about BC, but in the US 92 came with the 3FE motor and A440F fully hydraulic transmission.
 
So as it turns out my tranny is the A442F fully hydraulic version, so definitely not a solenoid issue. Tranny fluid was quite a bit overfilled. Pulled the pan and found the filter clogged pretty much solid with clutch like material. So now I need to find somebody to rebuild this thing and try and find parts........
 
So as it turns out my tranny is the A442F fully hydraulic version, so definitely not a solenoid issue. Tranny fluid was quite a bit overfilled. Pulled the pan and found the filter clogged pretty much solid with clutch like material. So now I need to find somebody to rebuild this thing and try and find parts........
OK, so you have an A440F transmission not an A442F. They are very particular about fluid level. At this point you have absolutely nothing to lose by cleaning the filter, refilling the transmission to the proper level, and seeing what you have.
Remember to add only 4 quarts of fluid and then start the engine for about 10 seconds to pump the fluid into the valve body. Then you can add the rest. Otherwise you'll just make a mess.
 
Not a A440F definitely a A442F, but an early one that is not electric, confirmed and double confirmed. These may be particular to the diesel imports I am not sure, there are threads on here covering it. That being said, it is very similar to the 440, same filter etc. Rather than have a ticking time bomb I swapped the tranny for my spare which as it turned out is also a non electric 442F. The tricky thing now is what rebuild kit do I order?
 
Back
Top Bottom