Need Help Compression Gauge Stuck

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Went out a tried just now. The plug socket still can't squeeze by. I also pulled the harness and heater valve off for more room. I am tempted to put some JB on the socket plug. Because it fit around the crimp on the hose pretty tight with the round end. I as thinking about packing a small rope of paper towels around the bottom.and maybe a business card. In case the jb seeped.
 
Is it possible for you to take a CLEAR picture (down the tube) of what we are dealing with. I am having a hard time seeing it in my mind (per description only). I'm sure we can come up with a solution, but I'd advise against using any JB weld at this point.

No doubt the adapter is now torqued against the threads...so a good amount of effort is going to be required to break it loose.

Pretty sure you are going to need to pull the valve cover so you can see what you are doing and have more room to manipulate any tools used.

Just remember...any JB weld that you use (I wouldn't use it) that gets anyplace unwanted....is only going to compound the situation. There is a 'mechanical' solution to this. We just need to see what you are dealing with.

LC cams.webp
 
Last edited:
You could also go buy an identical Guage setup ( assuming you can) and reverse engineer something. Possibly using the socket tube wrench thingy ( technical term btw)
 
You could also go buy an identical Guage setup ( assuming you can) and reverse engineer something. Possibly using the socket tube wrench thingy ( technical term btw)
Yeah I have one and started to use the hard long adapter. It would have spun it out for sure. But the the T at the top of it was hitting on the firewall. Not thinking how hard it had been torqued. I went with the hose. Which of course was a mistake. I should have cut the T off or used a old plug like pictured above. Unfortunately this crossed my mind about 3 minutes after I JB welded the hose into the adapter.

IMG_7392.webp
 

Pretty sure I asked for a 'clear' picture?

How deep is that threaded portion (approximately) and what would you estimate the diameter?

First thing I would do is spray a good amount of penetrating oil down around the adapter (and tube).

Does the adapter have an O-ring on it...or is just a solid thread into the head?
 
Can you grind down the OUTSIDE of the SOCKET to make it a thinner wall, enough to get around the adapter?
 
Actually it now has the hose attached to it. So I can't get to the inside anymore. There is no room around the fitting. My only hope is to get traction on the hose crimp. I loaded it up with penetrating oil overnight the first day. It didn't break it loose. And yes the rubber is on there. Sorry that pic is the best I had.
 
A short video with your phone will help everyone get a better idea of what exactly the situation looks like. I agree with @flintknapper that there is a mechanical solution we just need to narrow it down.
 
Cant you grab the hose with visegrips and turn until it either breaks or comes out? I mean one way or another you're going to need to get the hose out of the way. No?
 
Got that bitch out!!!!
I ended up driving a small Phillips into the hose end. I got it to break loose from the adapter. Then put a thin film of JBweld on a old plug. Went and watched the first motos at Redbud. Then twisted it out with a plug wrench.

IMG_7426.webp
 
Back
Top Bottom