Need gasket removal tips

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 8, 2006
Threads
52
Messages
2,523
Location
Vancouver (not BC), WA (not DC)
Hi all,

I need some tips on how to get the old oil pan gasket out of the grooves on the front and back of the engine. It is a 35 year old gasket, and it is not wanting to come out of those grooves. Any tricks you have used? I have tried a screw driver and a razor blade, but I'm only getting out tiny pieces. At this rate, it will take me about 6 weeks to get all the old gasket out. :mad:

Thanks!
 
I've only done a head gasket on a ford tempo, not too many grooves, but had to use razor blade, and lots of elbow greese. could you get a small pick and lightly tap it with a hammer (careful not to dent the oil pan) and work it free? Sometimes there are not tricks and it just takes a lot of hard work?

Good luck,
 
I use a old screw-driver, the same width as the groove, sharpened to a razors edge on the grinder, and use it like a chisel. That crap is a bitch to get off tho.:mad:
 
yup, a narrow scraper or sharpened screw driver will be the best way to do it.

DO NOT use a grinder/brillo disc/.... or anything that's pneumatic or a power tool cause you'll remove more material than necessary and might end up with leakage problems.

these gaskets are a bitch to remove, just keep working away at it......
 
Back
Top Bottom