Need exhaust Advice

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 14, 2013
Threads
18
Messages
77
Location
St. Louis, MO
So I failed safety inspection today due to exhaust leaks around the cats, so I ended up taking it to a very reputable exhaust shop in St. Louis. The people there told me they could not get a socket to bite on the top bolt of the cats (rust), they couldnt weld the flange on the cats (where the leaks are) and were not sure how to rework the cats if they cut them out. I have searched all over and am looking for advice and pics I can show them on replace the cats. Also wanted your advice, should I remove the cats completely? Should I have them install a 2-1 cat and leave the stock muffler in? Any advice is greatly appreciated.
 
When my exaust was leaking between the cats I would put exaust puddy on where the flanges meet. That got me by till I got new exaust. Seems like this fix would last a month or so.
 
Does Missouri smog test in the St. Louis metro area? If not, should be easy enough to do several options. If they do, then you've got to be more careful. Either go OEM ($$$) or something that is certified to work.

I agree with Phil, if the shop can't figure something out, then try elsewhere. This ain't rocket science.
 
Take a torch to the bolts and then try to loosen them or cut them off. Replace the gasket between the cats. Make sure you go back with a oem gasket or you will be doing it again.
 
Chopping/drilling/heating/beating old bolts is like mechanics 101. If the exhaust shop can't get a rusted bolt off, they aren't worth a damn :doh:
 
I agree with above...find a new shop. They should be able to disconnect the exhaust system from the down pipe and give them plenty of room to torch or grind off the bolt.
 
Mine looked that way and I used Vise Grips on both sides and broke loose the nuts. Then installed a new Toyota seal and a couple new bolts, tightened it up and was GTG.

If an EXHAUST shop cannot figure out how to get them apart, you need a different shop. You don't want them touching your truck.

Most exhaust shops' primary tools are Torch, Grinder, Cut-off saw, sawzall, and welder. Notice that hand tools are not on that list.
 
Took it to another shop and the guy said best bet would be to cut off the flange to the cats, drill holes for 02 sensors, weld in a new 2 in 1 out cat and use everything from there back. Quoted 650 to do this. Let me know your thoughts.
 
Back
Top Bottom