Need brake fitting adapter?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 7, 2005
Threads
288
Messages
4,857
Location
Columbia, SC
Does anyone know what type of fitting I could use to convert a brake flexline with a 10 mm female fitting on each end to an inverted type male flare fitting on one end.

I hace the s.s. hoses from Marlin and he gave me three hoses: 1 female to male type, and 2 female to female type. I only need two hoses for my rig to start with and they are the same hose. A female threaded end and a male threaded end.

Can this be done and make these other two hoses usable or do I need to contact marlin and return them for what I need?

Here is pic of what I purchased.
brakes_04.gif
 
that kit looks like it is for the front axle only...(1 female to female at each knuckle, and one longer female to male from the axle to the frame)
actualy, what you have could be the kit for an IFS minitruck...
i would check with marlin.
the adaptors should be available from any race shop,(summit, jegs, etc.) make sure to use the steel ones, the brass and alloy ones are not rated for brake system pressures and may fail.
hth, carl
 
I have had no luck. All I can seem to find is 10 mm male to -3 AN male adapter. If any of you out there are better at searching for this than I am, or know of a source other than Summit, Jegs, Earl's, or Willwood I would appreciate it.

Jeremy
 
Does anyone know what type of fitting I could use to convert a brake flexline with a 10 mm female fitting on each end to an inverted type male flare fitting on one end.

I hace the s.s. hoses from Marlin and he gave me three hoses: 1 female to male type, and 2 female to female type. I only need two hoses for my rig to start with and they are the same hose. A female threaded end and a male threaded end.

Can this be done and make these other two hoses usable or do I need to contact marlin and return them for what I need?

Here is pic of what I purchased.

I went through this and was never happy with the results. I just recently had a vendor for this company remake all the flex brake and clutch lines on my 78 FJ40. There are no adapters and the fittings are the same style that Toyota used originally (much stronger than the ones with the black plastic crimp cover). I have a rear disk conversion and the flex lines the vendor made are sweet. Again, not one adapter used anywhere. This company even had an inverted flair tee that mounts on the rear axle and uses my vent bolt from the original factory tee. These brake lines are far superior to anything I have purchased from MAF, SOR or BTB.

http://www.brakequip.com/

The vendor I used was

http://www.magillsquality.com/quality.htm

If you would like some photos of the installed flex lines, let me know and I will post them.
 
Last edited:
Back
Top Bottom