NAPA headache

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 22, 2016
Threads
55
Messages
232
Location
On the road
Website
www.nextgenoverland.com
So.....Being new to the LC world I did what I have done with all my vehicles when I needed parts...go to NAPA....big mistake. I ordered a cap, rotor and wires. The wires were too short, the cap had the wires pointed in the wrong direction, one right into my cooling hose. and the rotor was chincy.
In removing 3 of the wires I had installed....two fell apart. Um...nice quality. Guess it's OEM from now on!!
 
The dependability of a land cruiser is only as good as the parts you put in it. For critical engine parts stick with oem. I learned the Napa lesson many moons ago when I put an aftermarket water pump on my fj40. Never again. As listed above search Beno and he'll hook you up with great oem parts and customer service.


Pete
 
Being new I contacted Cdan not knowing he retired. Beno however has been contacted. That being said....how critical is the cap/rotor/wires to be replaced. They looked fine for a 200k motor. MUCH better than the ones I took off my past jeeps.
 
Oem wires have the date of manufacture printed on them. I'd replace them if over 10 years old and as part of a comprehensive base lining of you truck.
 
If you have an Ohm meter, measure the resistance. If you get less than 10,000 ohm's per foot of wire, they're OK.
Then, check the physical condition. Any cracks, weak spots or other concerns, time to replace.
Dan.
 
Congratulations!

Have you joined the local cruiser club yet? You may be able to find good OEM parts locally in a pinch. I've seen lots of rusted cruisers on the Boston craigslist. I'm sure the mud members up there can give you some great resources.
 
Congratulations!

Have you joined the local cruiser club yet? You may be able to find good OEM parts locally in a pinch. I've seen lots of rusted cruisers on the Boston craigslist. I'm sure the mud members up there can give you some great resources.

Hey, Local club is two states over and looks to be very involved in wheeling. Very few cruisers in my neck of the woods unfortunately.
 
plenty of venders for oem parts here on mud. Some are cheaper and some @beno have extensive knowledge.
Bit overwhelmed by the quantity, have contacts @beno via email on some cooling parts, just waiting to hear back.
 
Never too late to start a Maine club. I am moving back to Maine next week. There are a couple other Mainers as well on Mud.
If I was sticking around longer I would. Long story short lived here 16 years, have a cool cabin on the midcoast. Got sick of the winters and salt eating my cars, quit our $80kyr jobs and are heading south and west this November to explore. MAYBE making it back next year as a tourist only to rinse and repeat :)
 
Go to Arizona- it's great in the winters and awful in summer, but then you can visit Maine. Snow is why we left Massachusetts for AZ.
I will probably make it out there this winter. Trying to find a place to kill the winter months but still stay comfortable. Planning on camping etc etc. Would love a paycheck, but hard to find a job for such a short term unless it's digging ditches :)
 
Back
Top Bottom