Minor RTH

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 19, 2005
Threads
59
Messages
1,733
Location
Small Waves, FL
Heater hose bypass; sqeeezed pipe a bit. Is this ok, if not how to make round again?

Thanks
F4B01993-6477-4749-B7BC-FEC3C4E2E351.webp
 
Get a fat, round pin punch and LIGHTLY tap it into the hole.

You can also use a light hammer with light taps around the outside with a pin punch inside to act as an anvil to help shape it.

You MAY be able to start with a pair of pliers, however, based on the actual kink at the bottom, you will end up making it worse.

I've this many times on various vehicles.
 
Thanks; brass drift coming up.

LIGHTLY tap: repeat mantra
 
Thanks again. sorted out with punches from the inside then insert the fat end, tap and round.

Continuing with the rear heater delete.

The struggle is real: is it blood or Toyota red? Taste to find out.
 
Heater hose bypass; sqeeezed pipe a bit. Is this ok, if not how to make round again?

Thanks
View attachment 2040085

I did the same exact thing over a decade ago. In a total panic mode I called Dan and ordered a replacement. In the interim I massaged it back to mostly round using a socket and worm gear clamp. Had some scary moments when the socket fell back into the tube. I was able to get it mostly round. I used a longer piece of hose and used two clamps. This temporary fix has been going strong and leak free for 70K and 13 years. If I every have the dash apart I guess I can replace the mangled heater pipe.
 
Back
Top Bottom