Measuring drive line angle ... ?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 23, 2007
Threads
23
Messages
51
Location
Idaho
Have been reading post after post about CC and have found comments recommending the "measuring of the drive line angle" ...

How is it to be measured? I have read so much on CC and it just seems that there are quite a few variables.

I keep reading about "caster readings" ... but I have been around a Hunter alignment machine since a kid ... I am familiar with caster/camber when it comes to hub/tire alignment ... Dad has a shop back East. I still cannot figure out how the alignment of the hub center can have bearing on the driveline angle. Could not the hub center be correct when the driveline angle was not? What am I missing? I'm slow ... I know ... :doh:

I have OME 2.5 with Slee 1" spacers. Just replaced u-joints and here is a pic of the driveline after the Slee CC bushings (note Mobil 1 everywhere). Truck handles great but I am a perfectionist and want it to be perfect ... even if I can't tell anything is wrong ... I hate being that way! Maybe thats why I own a LC ... :rolleyes:
LC11.webp
LC22.webp
 
Ok ... maybe I didn't make myself clear!

An alignment machine operates within pre-programed specs. Caster/Camber/Toe are all preprogramed for make and model.

Can a Hunter/FMC machine have your caster within preprogrammed specs ... yet the driveline angle still be causing minor vibration?

How can you know what is the proper angle of the driveline?
How can you figure this ... is there a mathematical or just non technical way?

What should the alignment machine be reading on the LC with a 2.5 OME and 1" spacers?
 
Ok ... maybe I didn't make myself clear!

An alignment machine operates within pre-programed specs. Caster/Camber/Toe are all preprogramed for make and model.

Can a Hunter/FMC machine have your caster within preprogrammed specs ... yet the driveline angle still be causing minor vibration?

-- Yes, Your camber is directly related to your pinion, since you have a solid axle. With a lift the angle of the driveshaft has to increase since the height increases. Many of the 40 guys cut and turn the axle, so that the caster is right and the pinion is pointed at the TC (for a CV driveshaft), or they ensure that the pinion output matches the TC output (for a regular driveshaft)


How can you know what is the proper angle of the driveline?
How can you figure this ... is there a mathematical or just non technical way?

-- Like I mentioned above, there are 2 ways to set up your pinion angle. Set it pointing at the TC output for a CV driveshaft, or match the TC output. The angle of the pinion, and the slope of the driveshaft will give you the operating angle.


What should the alignment machine be reading on the LC with a 2.5 OME and 1" spacers?



Ryan.
 
Back
Top Bottom