Lift/Tire question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Rocknroll said:
Alright. I'm about to drop close to $2000.00 to get this done so let me know if I'm right. This is the plan, 4" ccot hfs lift with 1.5 shackles, front, 2.5 shackles in the rear. And I;m still planning on 33.12.50 15 st radials or same in good year mtrs. At least I've narrowed it down a bit LOL

If you run that much lift I promise you that later you will wish you had 35's. I ran almost that same set up with 33x12.5 swamper radials and the tires looked small. I went to a 35x12.5 MTR and they look great and don't rub with cut rear fenders. Only one front fender rubs (drivers side) at full compression. I need to extend the bump stops!

Later,
 
you could chuck in a 1-2" bodylift
you'd easily be able to stuff 35s in there with the 4" suspension, no rubbing or cutting...

just my .02
 
Just cut the fenders and put some nice UB40 spector flares it will look great and work much better, Larry
 
I run the 4" MAF lift, shackle reversal, 35x12.50x15 BFGs, 3.75" backspacing (with 1.5" front billet spacers) and they don't hit front or rear...

https://forum.ih8mud.com/showthread.php?t=78427

I like it, seems to work pretty well so far. No power steering either, yet.
 
Hey msahr. Great looking ride. That's about how I want mine to stand. I also loke the color. Mine is desert beige and I really like the combination of your tan with the black (bezel too). Was thinking of doing mine similar with all the hardware black as well. Thanks for your input.
 
Thanks!
 
msahr said:
I run the 4" MAF lift, shackle reversal, 35x12.50x15 BFGs, 3.75" backspacing (with 1.5" front billet spacers) and they don't hit front or rear...

https://forum.ih8mud.com/showthread.php?t=78427

I like it, seems to work pretty well so far. No power steering either, yet.

Can you tell how much trimming if any was done on the rear fender?
Thanks!
 
Just what you see. The flares were installed by the previous owner.
 
MOfj40 said:
Fenders are stock fr/rr. Stock steel rim w/ hubcaps (15x5.5, 3.5" backspacing). 68 model, so drums all around. At full lock to the left, the front passenger sidewall touches the tie rod zerk fitting- just enough to shine it up a bit. No power steering, so I'm not a full lock that often :D . At full articulation, tires are narrow enough to tuck up into the rear wheel well without touching the lip of the sheetmetal. Lift is courtesy of PO- unkown brand, stock shackles, no reversal.

I love the looks of your cruiser...those bogger look real nice...
 
Back
Top Bottom