Leaking where?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 25, 2005
Threads
29
Messages
289
My 80 has started letting a good amount of water in when it rains from somewhere on the roof/windshield area. It is dripping from the driver's side right at the top corner of the windshield.
I cleaned out the drains in the sunroof and that didn't help.

Could I need new seals in the sunroof? Or the windshield? I've not stripped out the interior to search for the true inlet area, and I guess I'll have to.

Any one have any ideas before I get into that? thanks
 
Two areas of problem;

The runoofs for the sunroff get clogged and start to create water in the cab.

If the windsheild was replaced, sometimes the wrong seal is used and sometimes adhesive is not used in the installation. Installers say its not needed, but it is.
 
When you say you cleaned out the drains did you mean you cleaned out the drain holes and lines. Mine did this and I had to flush out the drain holes with compressed air. The lines were clogged.
 
Romer said:
If the windsheild was replaced, sometimes the wrong seal is used and sometimes adhesive is not used in the installation. Installers say its not needed, but it is.

Also the windshield doesn't even need to be a replacement for it to leak. Over time the factory urethane will dry out which then could result in a leaky front windshield.
 
bfrank said:
I have this same problem. What is the best way to seal the windshield?

Thanks,
bfrank@Indy.rr.com



Pull it and replace the weatherstrip and re-seal.
 
Dan, I knew you were going to say that! :D

I have a number of maintenance type issues to address of this nature.:rolleyes::mad:

Thanks all for the input. I hope to be able to run through all this this weekend, but we shall see. I'll post any results for those with the same issues.
 
So I just got my windsheild replace and the installer was some sort of complete moron incapable of following instructions. Cut to the chase, he ended up using Bedding and glazing compound instead or urethane as a sealant. Shocker, it still leaks. Is bedding and glazing compound the wrong stuff to use instead of urethane to seal the glass and body to the weatherstrip? Oh, and yes I had used OEM weatherstrip that was purchsed from CruiserDan (thanks Dan).
 
Last edited:
They need to glue the glass to the gasket, and then glue the gasket to the 80. Failure to do so will result in leaks.
 
Thanks for the response but I am extremely ignorant. My question is the Bedding and Glazing compound the same as Urethane as far as a sealant? I appreciate your response.
 
No, not at all the same.
 
Back
Top Bottom