Knuckle swap shim alignment tool needed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

NeVrDun

SILVER Star
Joined
Oct 15, 2017
Threads
3
Messages
282
Location
Goodyear, AZ
I am soon to be swapping out my 1970 40 series front axle drum brakes for a set of 1987 60 series knuckles. In talking to coworkers and reading the various forums I am coming to the understanding that I need to get a hold of the shim alignment tool that many have talked about and passed around the country.
Does anyone have one that I could borrow for my build? I would certainly pay for shipping both ways and a healthy supply of beer to the owner if someone could let it go for a while...
Please let me know...
Cheers!
 
This is the tool. Apparently unavailable from Toyota now. I’m waiting to order one from @reevesci
B50805AF-5DB5-4DB1-892A-760BDAF85760.webp

This is a a write up on how to use it.
Steering knuckle centering tool instructions (FAQ)
 
Last edited:
That is a good deal I’m not sure what reevesci is thinking price wise but sounds like he is trying to offer his production one for less if it comes threw.
 
Last edited:
Yes, I think Jason is trying to get the price down, but I don't think his will be available for awhile, yet, if it happens.
 
I'm curious to hear if anyone has plugged these dimensions for the steering knuckle alignment tool into a 3d printer with tight tolerances and seen what comes out...
I am not sure what kind of longevity you might get out of a plastic / resin based part but I would be curious.
Thoughts?
 
I know you all will call me a liar, especially because I have no pictures but in the mid 80's I had to do some work on the knuckles on my 70 fj40. It has been over 30 years now so I can't tell you exactly how I did it but if I had to I am sure I could figure it out again. I was living totally off the grid at the time so had no power tools to speak of. Memory says I used a piece of 1/2 inch stock that I threaded, some washers and nuts. For the centering some old sealed bearings that i shimmed up. It took some time a lot scrounging and measuring but I got it done. I have driven many miles since then and changed the wheel bearings about three years ago and had it stripped down pretty good and everything looked to be in good shape. I hate to sound glib but what ever happened to good old american ingenuity?
 
Back
Top Bottom