Keystone monthly ride August 10th.

Cass007

 
Joined
Nov 1, 2009
Messages
1,239
Location
South Central PA
My rig sounds terrible. Had no idea I was making that much racket in the woods. Just ordered a new alternator, so I will try to figure out what is making all the noise when I install that. Both idlers, fan clutch, compressor and water pump are new. Hoping it is one of the alternator bearings going bad. I've been seeing voltage fluctuate when driving 11.7-13.7 amps via the scan gauge and the white truck holds very steady at 14.1-14.2
 
Joined
Nov 20, 2013
Messages
683
Location
PA
The aluminum housings on both actuators where the magnet cup sits are corroded to the point where the alignment cannot be maintained. I can futz with them on the bench and get them working, but they only work for a short while before going out again. Electrolysis is a bear...
 
Top Bottom