Jerry Can Location

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

That was made by a company called Stout Equipment in New Mexico, sadly no longer around because their racks were the best I've seen or used. But it would be easy to have someone competent fabricate something similar.

If you have time for some close-ups, I am sure we would all appreciate it :)
 
Here you go:

41983063084_d5bfa31c09_z.jpg

27832408377_e6ff64f875_z.jpg

27832407747_a8a48da386.jpg

27832407517_0756672902_z.jpg

41983062404_66e926c911_z.jpg


Zero rattles or flex. Weight is kept low but departure angle is affected very little. (If you went to a single jerry can mounted sideways it would not be affected at all.) On a bet I once lifted the rear tires off the ground with a Hi-Lift on the back of the jerry can mount.
 
Last edited:
^^ Love the double pivot set up.

D
 
Use a factory later tube tire carrier. , it mount to the left, with some simple modification you can mount the jerry can to it

Yep.

Be sure to reenforce the mount points, using plate steel.., like done on later 40s for the spare.

Otherwise, you’ll lose the carrier and find yourself fixing holes in the body.
 
Back
Top Bottom