Is this curve needed?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2009
Threads
33
Messages
250
Location
Oakley
I cut out a section of my drivers floor pan and realized I dont think I'm going to be able to replicate the curved part and bend the downward angle to provide the rigidity. Do I need the curve or can I just make it taper to the same point? Will the curve taken out create clearance issues? I can't remember how tight things were with the engine in.
20190107_172131.webp
20190107_172047.webp
20190107_181524.webp


Any help is appreciated.
 
@hooter thanks, but I bought a floor pan from Real Steel and was hoping to use it, but the panel wasn't contoured.
Screenshot_20190107-192327_Chrome.webp
I'm putting in a 4spd, so the linkage is not an issue. By the looks of your picture and as long as the late 2F/4SPD bellhousing is roughly the same length, I might be okay.
 
I don’t know... but, is there a possibility of cutting the curved portion, off of the old, and welding it to the new?

Just a thought.

That's a possiblity if need to. Thanks for the idea.
 
I’d keep that lip.

I cut my floor pan to include it, I used the Real Steel pan also.
 
Do you mean the curved lip near the hump or the lip on the door side?

Both.

One flange tacks to the inner rocker, the lip near the hump is there to add some rigidity to the floor pan.

I’d do all I could to keep it.
 
I plan on keeping a lip on the hump side, but my concern was whether the curved lip is needed or is there clearance enough to eliminate the curve.

I avoided cutting into the rocker because it was in good shape.
 
I plan on keeping a lip on the hump side, but my concern was whether the curved lip is needed or is there clearance enough to eliminate the curve.

I avoided cutting into the rocker because it was in good shape.


There’s plenty of room if that’s the way you want to go with it.


Another tip-I had to trim some of the RS floor pan at the very front to get mine to fit right.
 
I opened mine up a little further than yours. Keeping that lip was in my plans though.

ACEBB086-51C0-4998-8336-6E93EE898B3E.webp
57251375-08A6-4447-929C-64C326FA82FE.webp
BFA03BD7-182E-4DE7-B617-0A8520A99B9F.webp
 
I can see why you went that route. This is my first bout with replacing sheetmetal, so I didn't want to get too far over my head. Should be interesting.
 
I can see why you went that route. This is my first bout with replacing sheetmetal, so I didn't want to get too far over my head. Should be interesting.


That was my first time also.
 
Make sure you fit the floor all the way over to the outer rocker prior to welding. If you have to force the rocker to meet the floor it will cause all sorts of issues. A hint that worked well for me was to use sheet metal screws to mock everything up and the screw holes will also create spots to plug weld.
 
Back
Top Bottom