Among a few other issues these should be pointed out to potential buyers:
1) There is no place to put your rear plate on this bumper once it's mounted. No holes or hardware you pretty much have to figure it out yourself. I guess they think we are just going to glue it on or something.
2) They have made changes to the design not shown on the web site or mentioned to customers when placing an order. No longer have swing out stop pins as shown. They went to a bushing design and use friction to stop the swing outs.
3) They provided hardware that was not long enough so i had to go get different hardware to mount the swing out latches.
4) The four holes in the middle of my bumper do not line up with the four holes in the cross member so i'm pretty much screwed when it comes to mounting anything to the bumper at this point.
I covered the entire swing out posts with greese to prevent rust.
#1: true

#2: true
I talked to cam about this as i ordered the bumper assuming it had this pin. It came without and when i called him to discuss he said they were having so many issues with them breaking with guys slaming them that they just stopped using them. I do wish he had told me before hand.#3: Not true. If this was the issue you should have just called him and i'm sure he would have corrected the mistake.
#4: not true....at least on mine and jfz80's. maybe you sh ould call.
I have no affiliation, but these are stand-up guys and i will not stand around and let them get thrown under the bus so to speak.
), but let's not let that cloud an honest discussion of real world results. Plenty of others are buying this stuff and expect it to work to a certain standard. It will help all perspective buyers to understand what that standard is, "stand-up guys" notwithstanding.