Interior Pics

[Eldorado556]

I'm in the process of removing my back seat and converting the rear of the rig to a dedicated camping truck.

Britklr I'd like to see what you come up with once the seats are removed.

When I made my cargo box and sleeper panel I intended on being able to use the rear seats if needed. But now it seems unlikely that I'd use them. I'd rather have the extra cargo space.

My current sleeper panel sits atop the folded down seats. So I guess I'd just have to adapt it to work without them.

 

[DFXR]

I use these Auveco nylon fasteners that I get from a local automotive supplier. They just push in and remove easily so I can still access the space behind the panels.

Good luck.

Thanks!

 

[SNLC]

Great thread! I have some interior plans myself so really enjoying seeing what others have done.

I am planning to use Mastercraft Baja RS seats. Have not seen a Cruiser with these yet until just a bit earlier. On the MAF site there is a truck with some,

Man-A-Fre Advance Off-Road Solutions

I think they look great but I might want them to sit a touch higher. I like a high seating position to keep the legs, back and butt in good posture for long distance driving.

 

[jzilla]

Where do you get the ABS to make the panels?

 

[AdventureToolCompany]

Where do you get the ABS to make the panels?

Good question. They're homemade using your old door panels as the template.

Just FYI: I had my plastic company quote me the cost of them cutting these panels out, but due to the CAD design time, labor and material cost they would have been a lot more expensive then the average Mudder would be willing to pay. You can do them yourself for much less.

Good luck.

 

[jzilla]

The FYI was the answer I was looking for...So you just went to a plastic shop and asked for black ABS? What thickness did you buy?
About how much should I expect to pay? (So I don't pay too much).
Thanks!

 

[AdventureToolCompany]

It comes 1/8 inch thick in a 4x8 sheets and runs approx. $25-$30 per sheet.

Good luck.

 

[Eldorado556]

Installed a FJ62 dash grab today.

 

[Eldorado556]

.44 mag Ruger Redhawk cylinder is my new shift knob.

 

[hatman406080]

 

[klinetime574]

Eldorado how quick can you get that back in the gun for protection? haha

and hatman I know you're bluffing!

 

[polarweasel]

Oh man, I hope Hatman's not bluffing. That's so ugly it's fabulous!

And Eldo, does that hurt when you shift? I like...

 

[doug720]

This looks like a reptile! A LizzardCruiser?

 

[dpr64]

Anyone know what brand these seat covers are? Where to buy?

 

[klinetime574]

Anyone know what brand these seat covers are? Where to buy?

They look like SOR Tuff Duck Covers with a TEQ logo stuck on to me.