D
Reactions
672

Latest activity Postings Media About Badges Post areas

    • D
      DFXR reacted to cruiseroutfit's post in the thread H55 and transfer case with Like Like.
      We would love to help @ Cruiser Outfitters. We stock new transmissions, new t-cases in several different ratios and every part in between. We can shop a tranny as soon as today! :cool:
    • D
      DFXR reacted to Spike Strip's post in the thread 15" vs 16" Wheels Pros and Cons with Like Like.
      @Tennessee80 No, I made a mistake on your post, cuz the ones you posted look like them, but those are 8" wide Wheels I'm after are 12-670604 (7" wide) https://www.summitracing.com/parts/wvi-12-670604
    • D
      DFXR replied to the thread 15" vs 16" Wheels Pros and Cons.
      I don’t know exactly which ones @Spike Strip is looking at, but mine are that same wheel, but 16x7. Also 4” backspacing.
    • D
      DFXR replied to the thread 15" vs 16" Wheels Pros and Cons.
      No issues with balancing. I had Big O mount + balance the tires and then I put them on and did an alignment in my driveway, and have been good since (maybe 5K miles).
    • D
      DFXR replied to the thread 15" vs 16" Wheels Pros and Cons.
      I have the Vintiques in 16x7 with 255/85-16 Cooper Discoverer S/T. Love the setup. As you probably know, no spacers necessary with the Vintiques. Driveability is great… but I came from 33x9.5x15 which always felt a little squirrely in the...
      • E098F43E-9CB8-480F-B860-7CB340AA3B3B.jpeg
    • D
      For reference - CA-smogged 2F with aluminum radiator and relatively new Toyota water pump and fan clutch, and a very new 190* thermostat. I get my temp numbers off an in-line Koso gauge that has its sender installed in the coolant line that...
    • D
      DFXR replied to the thread 1985 FJ60 on emissions connection.
      Whoops, what these guys said. I should have just gone out and looked!
    • D
      DFXR replied to the thread 1985 FJ60 on emissions connection.
      Looks like it's the vac line off the "Lower" port on your HAC valve. According to the emissions schematic below, that should go to port 11 on the metal racetrack thing. (I drew that circle around the vacuum advance at upper left for something else)
      • 2F_emissions_schematic-1.jpg
    • D
      Recently having electrical problems with both my cruiser and my boats mercruiser that needed fixing I was stumped. Finally I got my wife to look at the non working gauges while I was in the motor areas. The gauges would go on and off while I...
    • D
      Way easier to pull steering wheel if I recall than f w/ the relay rod. I’ve messed w/ my relay when doing a driveway alignment and it gets irritating when tweaking that area. I actually still need to do this because my wheel is cocked to the...
    • D
      DFXR reacted to Dunbar's post in the thread What should I sell with Like Like.
      Put the Vortec in something else and get rid of the A440F for an H55F. Sent the head to Jim Chenoweth for SS chevy valves and a 3 angle valve job. If the compression is good run it. Otherwise rebuild it after having a machine shop balance the...
    • D
      DFXR reacted to HeavyMetal12's post in the thread Introduction with Like Like.
      It came out of an LS400. It's got toyota badges all over it. I'd be happy to send pics. I didn't consider oil pan being very close to the diff housing. I'm going to put a rear oil pan in to clear it. Another small issue is vibration in the drive...
    • D
      DFXR replied to the thread Introduction.
      Looks like a great setup. People here will want to see pics of the 1UZ swap. What did the donor motor come out of?
    • D
      the 2F engine manual has details on carburetor adjustment. You can download a copy of the manual from the resources tab above. Sadly, however, there is really nothing about adjusting the closed position of the choke. When the throttle is fully...
    • D
      DFXR reacted to 2mbb's post in the thread Throttle linkage help with Like Like.
      ^^this. Open the choke plate and look down the primary throttle bore. Is the throttle plate open (vertical) or closed (horizontal)? If it is vertical, disconnect the linkage and see if it closes. If the throttle is open, snap the rod end off...
    • D
      DFXR replied to the thread Throttle linkage help.
      Your throttle looks like it's wide open at the carb, which I guess is obvious since your pedal is at the floor. Look at the parts I circled and compare to @NeverGiveUpYota 's photos. I am assuming this was taken with the engine off. The spring...
      • 9B338B1F-3058-4EFF-9999-6F4C3497C4C9.jpg
    • D
      DFXR replied to the thread Glovebox help.
      Cruiserparts will likely have that kind of hardware used, but not necessarily listed on their site.
    • D
      DFXR reacted to Crick60's post in the thread I’ve done a bad bad thing 61-300 with Like Like.
      Does this count as a 361 series?
    • D
      DFXR reacted to FJ60Seth's post in the thread Shoutout to Seat Belt Planet with Like Like.
      Not only does Seat Belt Planet have excellent products, their customer service is beyond outstanding. I purchased replacement front seat belts for my 1983 FJ60, and 2 years later got around to installing them. Weirdly, my floor plan is shaped...
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top Bottom