Interior Panel Snap Holes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 1, 2016
Threads
19
Messages
229
Location
Utah Valley
Kind of a weird title.... but I've been doing a crappy job when taking my door panels off and have destroyed several of the holes where the snaps go to hold the panel onto the door.

Anyone aware of a convenient solution to fix the destroyed holes? Like a precut mesh or something? Im guessing there is a tool I should be using besides a screwdriver too...

IMG_0791.webp
 
Quick fix could be a small piece of sheet metal with that hole pattern cut into it and glued (contact cement?) to the back to cover the bad area and extend onto some more solid material. I have one in my front door that's bad and thinking of doing this.

You need to get some interior panel removers. Can get them in a set at harbor freight for next to nothing. Really makes removing those plugs a lot easier.
 
I can't find it now of course, but I've seen where folks use liquid (not gel) superglue and let it soak into the particle board around the holes. When it hardens, the existing holes are reinforced. I'll keep looking...
 
I had the same issue... soaked the hole with elmers glue, and reinforced with cardboard pieces also soaked with elmers glue. Has held up pretty well.

I like the superglue idea though.. seems like a stronger solution
 
This

Trim tool set label.webp


Trim tool set.webp
 
Back
Top Bottom