intall kits for da R&P (1 Viewer)

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

lowtideride said:
Hey brudda thanks for the hook up....the velveeta thanks you!!!!!

The velveeta has some parts coming... :D
 
HAha...dude I love the sticker ya sent me....its on the girls car now..


Need a lil help here..

I dont know what dial meter to get..

I found a 6" dial caliper and the auto parts store...its the only thing i found out of the 48 shops i went to...will that worK? im not looking for the best friggin tool im just lookin for what will work...

thanks again..
-Al
 
as long as it is good to .001 you will be good
 
Yulp thats what i need. somthing to measure the backlash.....nope the thing i was lookin at looks a lil bit diffrent than that..it was called a dial caliper and well looked a little diffrenet.

Mace you know a place that would have that? i was planning on getting the gears in this weekend. i dont have time to order that dial...wish i knew sooner.....ignorance is not bliss by any means...


and thanks for all the help man. :beer:
 
most cheapie hardware stores have them.

You got a harbor freight around ya?
 
if you could find a way to mount the 6" dial caliper you might be able to make it work. But what a PITA..

I assume you don't have time to order through HF then...
 
mace, i've been tryin to find him on out in florida, we are not having very much luck.
yellow pages.com shows a bunch of tool suppliers but i couldnt get thru.
auto zone.com showed one but no stockie.
recomended he might have to go into jacksonville to find one.
i've got a third sittin in my garage, i'm gonna see if i can pull some specs off it,
like 1/16 or 3/32 something like that and match it up to what the FSMspecs are.

trying to help a brother out!!!!
 
I thought the backlash was supposed to be more like .006-.009 (or so)
:confused:
 
Mace said:
I thought the backlash was supposed to be more like .006-.009 (or so)
:confused:

i'll have to look but i think the front spec was like .002-.022 i could be wrong
i'm sure the rear is a diff spec
 
rear should be the same as front.
 
Well i went out and drove around to diffrenent spots and came up with nothing...is there around this with out using it? i will got pick up the 6" inch one and see if i can get it to work....But im worried about pulling it apart with out have the right parts to put it back together......right.. ahh what a pain.




2Bad you have gone above and beyond thanks for all the help man..
 
Hey Al theres a couple Harbor Freight stores in Jacksonville, they might have what you need.
 
I'd go the jacksonville route.

s***, I'll send you the one I have if that helps.
 
Mace said:
I'd go the jacksonville route.

s***, I'll send you the one I have if that helps.

i just got off the phone with al,
he's gonna call the h/f store in jacksonville.
 
I'm off to Jacksonville they said they had it....hope they do....im sure i'll be deaf after this 3 hour drive
 
Last edited:

Users who are viewing this thread

Back
Top Bottom