Inside frame loose nut

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 24, 2011
Threads
35
Messages
239
Location
Orange County, CA
So.... I have this little problem. While trying to upgrade hardware on my rear bumper, the 12mm nut inside the frame came loose :bang:.
Don't have a big enough opening near to hold the nut on the inside and now I'm afraid of removing any other bolts.

I know there is a super simple trick to tighten this nut. (Yea right )

Suggestions guys?

image.webp
 
There may be a super simple way, but I don't know it. Faced with that issue, my first thought would be to drill a couple of holes, one one either side of the bolt hole, and try to plug weld the nut in place. Then I'd oil the crap out of the rest of the bolts, and heat them if they still offered resistance. Did you have to crank on that one?
 
superglue?
 
It looks like it may have been cross-threaded or the wrong pitch.

I had one come loose on mine, but it was towards the back and easy to reach after I got the rest of the bolts out. Luckily, I was taking the old bumper off when it happened. I had to use an abrasive wheel to cut it off. I welded in a new nut since it was close to the back end.
 
I would cut the head off that bolt with an angle grinder and leave as much of the bolt as I could, just remove enough to get the bumper off. Then drill a few holes at the edge of that existing bolt hole and plug weld them as mentioned above, grind them flat and paint them. Any other bolts that are too tough to unbolt, cut the heads off of and thread a washer and nut onto them and plug weld the nut on. Remove it while hot.
 
Thank you guys. Looks like I'll have to wait until after the trip this weekend to take it to a welding shop.
Does anybody have experience with this blind hole system? Somebody told me they work very well but don't know where to get it.

image.webp
 
They make a piece of wire that threads around a bolt. I used one for 1/2" and threaded the bolt thru the hole in frame then pulled the wire thru so bolt head was in frame with threads sticking down.
The only worry with this is that the bolt can turn, but mine did not and I can replace if ever needed.
If bolt head turns tack weld, or have a shop do it. Make sure they unhook battery, or 2 min job could be a $1000+ ECU job.
I used the Irwin Bolt out Kit after the heads snapped off the bolts trying to remove them.
The kit was cheap on Ebay and worked well.

BOlt Threading Wire.webp
 
Back
Top Bottom