Info Valve Cover bolts......? (2 Viewers)

[Tools R Us]

My 1993 manual does not list this fastener specifically. Referring to the standard bolt torque spec sheet in the front of the manual, this bolt has 3 hash marks which makes it a 7T. The spec for a 6mm 7T fastener is 9 ft/lb.

The same torque figure from two different manuals, using different reference points.

The ones I have (from an OBD2 motor) have 4 marks, so 8T. The '96 LX450 FSM doesn't have a spec for M6 8T, for 7T lists 8ft/lb.

 

[Tools R Us]

The highlighted figure is for the bolts going from the cylinder head down into the timing cover.

And those are M8, so whole nother kettle of fish.

 

[Joe Link]

Did we ever get this figured out?

 

[BILT4ME]

Did we ever get this figured out?

Yes. Re-Read, starting at the beginning. Read ALL the way to the end.

Let me summarize:
P/N 90105-06221
6mm x 24.66mm x 1.0 bolt
The '96 LX450 FSM shows 9ft/lb.



Oh....and don't break off your nipples.

Edited to correct from 22mm to 24.66mm per Beno Onur

 

[OGBeno]

Yes. Re-Read, starting at the beginning. Read ALL the way to the end.

Let me summarize:
P/N 90105-06221
6mm x 22m x 1.0 bolt
The '96 LX450 FSM shows 9ft/lb.



Oh....and don't break off your nipples.

It's 30.43mm long including the head and flange. It's 24.66mm long from flange face to tip.

 

[Tal]

I know this was soo long ago, but would anyone know where I could purchase these bolts online for my 1fz? I live in the bush and cannot source them anywhere out here. -.- if anyone sees this thanks in advance

 

[MoJ]

I know this was soo long ago, but would anyone know where I could purchase these bolts online for my 1fz? I live in the bush and cannot source them anywhere out here. -.- if anyone sees this thanks in advance

Simply google the part number listed above