Idle Up / Cold Idle dash switch?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 23, 2010
Threads
285
Messages
3,283
Location
Kamloops, BC
Website
www.forgottenbc.ca
Has anyone seen any OEM Toyota dash switches for "Idle up" or cold/high idle that would fit an 80 series switch hole?

Since removing my ACSD (sorry, diesel thing..:p) when it's really f'ing cold out, my idle is too low. I'm too lazy to operate the hand throttle :p and want to be able to just press a button to temporarily increase the idle by a couple hundred rpm, by tying into the AC idle up circuit and using the VSV to naturally idle up the engine.

:popcorn:
 
Dunno if your AC is wired the same as on the 22RE, but I'm gonna do this with the idle-up solenoid on mine. I don't have AC anymore, so it should be easy to wire up.
 
My '96 Hilux Surf had one.

I used to have it wired to the aux trigger on my command start so I could idle up from inside the house/office, worked pretty slick.

How cold is "really f'ing cold"? I never got around to removing the ACSD on my last HDJ81, but I was always concerned about how it would start/run without it when it's really cold, and it gets REALLY cold here.

27815_1274288305.webp
 
I consider - 35 and colder really f'ing cold :)

Ian and Douglas, you may recall the issues I was having with cold starts this winter. That was because of the leaky seal in my fuel heater assembly. I've corrected the issue, but haven't had anything colder than -25 to test with. It started fine at -25 after my repairs whereas it wouldn't start at -14 beforehand, even plugged in. The bad O rings in the fuel heater would let too much air in and stall the truck.

This idle up switch isn't to fix anything like that, it's just so it idles at around 1100 when cold instead of 400 like it does now in negative temps .
 
I pulled the ACSD on mine. Still starts at -40 not plugged in if I need it to.

Ticking nose disappeared too, you don't want that thing to fail and take out your pump/injectors.

What does your truck idle at when it's really cold? Do you have to use the hand throttle to bring the idle up in those conditions?

You're absolutely right, I don't want the ACSD to take out my pump or injectors, but why not replace with a new ACSD instead of the delete? Cold weather starts are a fact of life for you and me, and I'd like to be able to use my command start without worrying if the truck will stay running.
 
I believe the truck will start just fine, but one of the things the acsd does is bump up the idle similar to the AC.
You may notice a bit more smoke until it's warm. Acsd also increases the timing a tad.

I guess you could replace the acsd as a maintenance item... Like rod bearings on the 1hdt, though I shudder how much the bugger costs.
 
What does your truck idle at when it's really cold? Do you have to use the hand throttle to bring the idle up in those conditions?

You're absolutely right, I don't want the ACSD to take out my pump or injectors, but why not replace with a new ACSD instead of the delete? Cold weather starts are a fact of life for you and me, and I'd like to be able to use my command start without worrying if the truck will stay running.

It idles the same cold as warm, around 800rpm if my memory servces me correctly. I try to limit my idle time as much as possible, as excessive idling is really hard on the engine (anything over three or four minutes and I use the hand throttle to bring it up to 1200rpm or so). Having the ACSD would probably be benficial if you use command start.
 
Fast forward 3 years, does anyone have the pinout on this OEM Toyota Idle Up button? It's NOT a "click-in / out" type switch, it's a press and release.

IMG_20180305_163603.webp


IMG_20180305_163630.webp


IMG_20180305_163707.webp
 
Back
Top Bottom