Hydroboost brakes?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 3, 2004
Threads
35
Messages
665
Location
Juneau, AK
Has anyone ever run hydroboost in a 'cruiser with the factory front brakes, rear disc kit, and 33's?

I'm planning on adding power steering shortly, and I'm debating upgrading my brake master with it. I'm gathering parts for a dana 60 swap, but that's at least a year or two out.

So will this make my tires lock up insanely easy? I switch back to stock sized studded tires in the winter, since it gets rather icy around here. The rears already lock up pretty easy (though I have a proportioning valve that takes care of that).

Or should I wait until the 60 swap?
 
I put hydroboost on my rig awhile ago . Works extremely well.The pics kinda show what I did
PC290188.webp
PC290189.webp
PC290190.webp
 
What mod is that that you did to the pedal? Is that so it flows less? If you put it in the lower hole, would it push a lot more fluid?

What size tires are you running on that rig? I assume that's the big one in your .sig?

What all did you do to the firewall? Is it possible to put the stock booster back?
 
the hydroboost unit is out of a 2000 astrovan , the master is out of a 2001 blazer (4 whl disks) I used cruiser 4 piston calipers on all four corners and currently am running 37 mtr's .I had 38" swampers on it and it stopped just as well. The pedal ratio is about 4.5 : 1 .Since the hydroboost unit uses hydraulic pressure from the pump to apply the brakes , The way I have it setup is more than adequate as far as pedal travel goes . I'm not sure about the overall length but I'll try to measure it tomorrow . The cab is from a 1966 fj45 so I'm pretty sure it didn't have a booster originally that was why I went with the hydro unit .It was the only thing I found that would work well in the confined space.
 
Back
Top Bottom