Hydro Winch

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 15, 2014
Threads
27
Messages
135
I just bought a lightly used MM 9000lb winch and I thought I had found a thread before with images where to route the lines but I seemed to have lost it and can't find it again with all my searching. Can anyone show me how the routed their lines to the PS pump please? I appreciate it.
 
Landtank. I think that might be it. I'm still a little confused on where the hoses get connected to the PS.
 
I guess the part the confuses me is, do I need a block in order to have more access points to the power steering?
 
What he said, if you use a manifold then you will lose power steering while using the winch.
 
Now I understand. So PS fluid will always pass through the winch. For some reason I thought that it would not allow flow while not in use.
 
You need to buy this kit:
https://www.summitracing.com/parts/mmk-35-5020-41

Those fittings go from the pump to the winch, and then the winch to the steering box.. if I remember correctly.

You could buy this kit to get the hoses as well:
https://www.summitracing.com/parts/mmk-34-5020-41
But you can have those made. You just need two hoses that have a good burst strength and the the fittings from the first link.


Here are my install pictures (Not many)
https://goo.gl/photos/Q3BTnjqSru5QAJ196

I have been running the same MileMarker 10,500lbs hydraulic winch for about 13 years. Had it on a Discovery II for 11, and my FZJ80 for the past two years. Never had a problem at all.

I cut a hole under the battery tray and fed both hoses through that and to the winch.
 
Back
Top Bottom