Hub damage, still usable?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 6, 2013
Threads
2
Messages
8
Ahoy all,

I'm in the process of a front axle rebuild on my LX450 and am looking for some advice. I gave my hub a pretty good beating in the process of separating it from the rotor and am concerned it may cause issues down the road. Is this thing still usable? Should I try and grind down the rough spots? Leave as it? Any advice welcomed.

(Apologies I've yet to do a proper introduction thread. Thanks to everyone that has made this site the wealth of information that it is.)

Thanks,
Adam

IMG_20160402_143036.webp


IMG_20160402_143047.webp


IMG_20160402_143103.webp


IMG_20160402_143143.webp
 
Last edited:
I agree with inkpot...clean it up and you should be good to go. Use a straight edge to be sure the face is flat again. No high spots where it mates up/bolts up.
 
Thanks for the tips everyone. Feeling much better about it. Will try and avoid this on the other side.

IMG_20160402_184352.webp


IMG_20160402_184254.webp
 
Back
Top Bottom