Howell TBI help

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 9, 2018
Threads
14
Messages
59
Location
Alaska
I know I'm posting in the wrong area. I was told to come check out this forum and ask questions. Ive got a Howell TBI kit for my 84 fj60. I need help with installing it because the instructions are a little generalized.

1. Where would be the best place to mount the new fule pump?
2. How do I attach the throttle linkage to the TBI it's self?
3. Removal of the push rod. Is it necessary? Do I remove just 1? I thought there were more than 1?

Any information would be very much appreciated.
 
1. Assuming you are using a 15 psi electric fuel pump, mount it as close to the gas tank as possible (just under the floorboard), electric fuel pumps are pushers, not suckers.
2. Normally you'd convert to cable linkage, then hook-up is a no brainer (oh, I forgot, you didn't get a Downey installation instruction sheet).
 
The instructions sent by howell said to remove the push rod. But that doesn't make any sense. Their instructions seem to be a generalization for all veichal.
 
a simple way way to do a TBI on a 60 or 40 is to ask Howell for a TBI with the bellcrank style linkage then use a GM cable and
cable bracket from a TBI chevy van.

31t5tVLwoGL.jpg

The three threaded bosses on the side of the TBI held a cable bracket so you don't have to mess
with finding a place to mount a stand for the cable

IMG_7336.webp
 
Back
Top Bottom