How high will you rev your engine?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 22, 2017
Threads
110
Messages
404
Location
SW Washington, USA
Website
instagram.com
Hey I've got a question for everyone who hasn't swapped their motor. I finished rebuilding my factory 1F engine almost a year ago, and since then I've been very protective of it. Borderline OCD to the point where I'll avoid long trips lol.

So I want to know... How high will you rev your engines, and for how long? I have factory gearing and 33" tires which help, but it still stresses me out even to drive for 30 mins on the freeway pulling 2500 or 3000 RPM.
 
I run 3K for 1hr+ fairly regularly in a '78 2f that burns a bit of oil and no problems thus far (knocks wood). I think 3k is fairly conservative but will let those more expert than I weigh in...
 
I generally shift at 3k around town, take it to 4k(very briefly) when getting on the freeway. Pig likes to cruise around 2500 so that's what we do. I'm on 37s with 4.88s now, no idea what speed I'm doing except that it's relatively slow. I got a balance job with my rebuild, might have helped some. Pretty sure I took it over 4k (on 35s and 4.11) climbing dunes at Pismo when the rebuild was fresh...
I was not watching the tach
nn0w.jpg
 
Tractor engines, low and slow will make them last IMO. Similar thread a few years back and 2800 rpm kept coming up.
 
I shift at about 3,000 rpm; lugging them will burn the valves.

I've driven 700+ mile days at a continuous 2,500 rpm / 65 mph (3.70 diffs, 33" tires). I've driven it faster than that for shorter periods of time when absolutely necessary, but 2,500 rpm is about the sweet spot for the highway.
 
I just did some tests on my 78. I'm running 33" tires, and at 2750 RPMs I'm going 61 mph.

This is where it seems to be happy... 2500 - 2750 rpms... = 55 - 61 mph...
 
Back
Top Bottom